Strong SM-RBX-14-WH Template

THIS MUST BE PRINTED ON AN A3 PAGE (17” W X 11” H) SHEET OF PAPER AT A 1:1 RATIO!

INSTALLATION INSTRUCTIONS

1. Tape this template to the drywall

Center the template between two studs. Make sure that it’s 14” W x 8” H

2. Mark the Location of the holes.

Use a punch or screw to mark holes in each corner.

3. Remove the template and drill the holes

Use an 1/8” or smaller bit, drill through all the holes marked in previous step.

4. Cut the drywall opening

Use a drywall saw to cut between the holes drilled.

Please be sure to check printer settings so no re-sizing occurs.

SM-RBX-8-WH Cutout Template

140529-1014

Ten podręcznik jest również odpowiedni dla

ściągnij PDF