25300 AL MOEN DRIVE NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321-8809 FAX: (800) 848-6636
INTERNATIONAL: (440) 962-2000 FAX: (440) 962-2726
CUSTOMER SERVICE (USA): 800-882-0116 FAX: (888) 379-2720
WWW.MOEN.COM
Copyright Creative Specialties International Literature #BA1348
Directions below are for installation into drywall. If installing product into a stud, use the
wood screws only.
1. Position the mounting template on the wall in the desired location.
2. Using a level, align the template and tape it to the wall.
3. Drill tw o 5/16” holes at each mounting post location. (We recommend using the
horizontal holes for drywall installation).
4. Remove the template from the wall.
5. Fold ends of the plastic toggle together and insert into each hole in the wall.
6. Lightly tap anchors until flush with the wall.
7. One at a time, insert plastic pin into each of the anchors and lightly tap to activate
anchor. Remove pin and repeat on all anchors.
8. Remove mounting posts from the product assemblies by loosening each setscrew.
9. One at a time, place each mounting post over anchors (notch facing downward)
and insert screws through post into anchors. Tighten screws.
10. Loosen the 2 small screws on each of the end posts.
11. With the back of the mirror facing you, slide both end posts into position on the
mirror. Align the screws with the holes in the back plates. Tighten all 4 screws.
12. Place entire mirror assembly over the mounting posts on the wall (setscrews facing
down). Tighten setscrews.
Oval Tilting Mirror posts are
constructed of zinc and mirror is
constructed of 5MM thick glass.