Strong SM-RBX-8-WH Template

STUDSTUD

INSTALLATION INSTRUCTIONS

1. Tape this template to the drywall

Center the template between two studs. Make sure that it’s 14” W x 13 ¼” H

2. Mark the Location of the holes.

Use a punch or screw to mark holes in each corner.

3. Remove the template and drill the holes

Use an 1/8” or smaller bit, drill through all the holes marked in previous step.

4. Cut the drywall opening

Use a drywall saw to cut between the holes drilled.

Cutout Dimensions - 14” W x 13 ¼” H

THIS MUST BE PRINTED ON A 17” W x 22” H SHEET OF PAPER AT A 1:1 RATIO!

SM-RBX-14-WH Cutout Template

Niniejsza instrukcja jest również odpowiednia dla

Pobierz PDF