AMP Lighting AAL-30XXIR Series Installation & Maintenance Manual

Marka
AMP Lighting
Model
AAL-30XXIR Series
Typ
Installation & Maintenance Manual
AMP
®
Low Voltage Landscape Lighting
AMP
®
One G2 ControlPro
TM
300,500,800
AAL-30XXIR Series
INSTALLATION & MAINTENANCE GUIDE
Help Hotline:
1-813-978-3900 • Mon-Fri 8am-8pm
www.amplighting.com
AMP
®
One G2 ControlPro
TM
300,500,800
AAL-30XXIR Series
Important: Please Read Before Installation
Important: Safety Instructions
INSTALLATION & MAINTENANCE GUIDE
This luminaire is intended for installation in accordance with local codes
and the National Electric Code (NEC). Failure to adhere to these codes and
instructions may result in serious injury, property damage and void the
warranty.
These instructions do not intend to cover all variations in installation,
operation maintenance or mounting situations.
1. Make sure that the power is turned OFF before installing or servicing this
luminaire.
2. WARNING: risk of electrical shock. Install all luminaires 10 feet (3.05M) or
more from pool, spa or fountain.
3. This luminaire is intended to be used only with a power supply
(transformer) rated maximum of 300 watts (25 AMPS) at 15 volts.
4. Wiring connections must be made with wire connectors that are suitable
for outdoor use.
5. Position the low voltage wire and wire connector so that it is located
within 6 inches (15.2 cm) from a building structure, a luminaire or tting.
6. The main low voltage cable is intended for shallow burial - less than 6
inches (152 mm).
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS
Lighted lamp is HOT!
WARNING – TO REDUCE THE RISK OF FIRE OR INJURY TO PERSONS.
1. Turn off/unplug and allow to cool before replacing lamp.
2. Lamp gets HOT quickly! Contact only switch/plug when turning on.
3. Do not touch the hot lens, guard or enclosure.
4. Keep lamp away from materials that may burn.
5. Do not touch lamp at any time. Use a soft cloth. Oil from skin may
damage lamp.
6. Do not operate the luminaire tting with a missing or damaged shield.
SAVE THESE INSTRUCTIONS
!
!
[email protected] • 813.978.3900
–3–
www.amplighting.com
Product Dimensions
–4–
Package Contents
Parts Required (sold separately)
A. (1) Fixture
B. (1) Stake
A. (1) Design-Master Remote
Control
TM
3.25”
3”
1.75”
1.75”
2.5”
3.5”
AAL-3000IR AAL-3001IR & AAL-3002IR
[email protected] • 813.978.3900
INSTALLATION & MAINTENANCE GUIDE
–5––5–
Install Stake
1
Determine the desired location for
mounting the xture. Hammer the stake
into the ground until ange of stake
is ush to grade. To avoid damage to
the stake, place a board on top of the
stake while hammering.
NOTE: If the ground is hard and the stake
is difcult to install, make a crosscut in
the ground using a at shovel.
Board
Stake
Soil
Ground
Install Fixture to Stake
2
Clear away an area in the ground at the
wireway slot on top of the stake. Lay
the luminaire pigtail into the wireway
slot and screw the xture on to the
stake. Tighten until snug.
Fixture
Stake
Pigtail
Wireway Slot
www.amplighting.com
AMP
®
One G2 ControlPro
TM
300,500,800
AAL-30XXIR Series
–6–
Remove Glare Guard
4
Unscrew the set screw and remove the
glare guard from the xture.
Glare
Guard
Set Screw
Fixture
Remove Outer Ring
5
Unscrew the xture lens and remove it
from the xture.
Fixture
Lens
Fixture
Wire Connection
3
Strip both the leads from the luminaire pigtail. Using two wire connectors
(sold separately), connect the leads from the luminaire to the main supply
cable leads.
Pigtail
Main Supply Cable
Wire Connectors
Install/Replace Optic
[email protected] • 813.978.3900
–7––7–
INSTALLATION & MAINTENANCE GUIDE
Replace Optic
6
Optic
Screw
Fixture
Loosen the screws, and remove the
optic from the xture.
Install the new optic in the xture and
reverse Step 3 - Step 1. Conrm the
optic is properly aligned over the
LED board before tightening down.
Improper alignment when tightening
the screws can cause the optic to
break.
LED Board
www.amplighting.com
AMP
®
One G2 ControlPro
TM
300,500,800
AAL-30XXIR Series
Specications and product details subject to change without notice.
© Copyright 2018, AMP
®
Lighting, Lutz FL USA 33549 • All rights reserved.
[email protected] • 813.978.3900
Help Hotline:
1-813-978-3900 • Mon-Fri 8am-8pm
www.amplighting.com
is-AAL-30XXIR-ver4.pdf
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

AMP Lighting AAL-30XXIR Series Installation & Maintenance Manual

Marka
AMP Lighting
Model
AAL-30XXIR Series
Typ
Installation & Maintenance Manual
Pobierz PDF
raport

w innych językach

Powiązane artykuły

Inne dokumenty