Towel bar posts are constructed of
zinc. Bar is constructed of brass.
DN7718BN – 18” Towel Bar
Brushed Nickel Finish
DN7724BN – 24” Towel Bar
Brushed Nickel Finish
DN7718CH – 18” Towel Bar
Chrome Finish
DN7724CH – 24” Towel Bar
Chrome Finish
Cleaning Instructions:
1. Position the mounting template on the wall in the desired location.
2. Using a level, align the template and tape it to the wall.
3. Drill tw o 5/16” holes at each mounting post location that corresponds to your
product.
4. Remove the template from the wall.
5. Fold ends of the plastic toggle together (see Figure 1) and insert into each hole
in the wall.
6. Lightly tap anchors until flush with the wall.
7. One at a time, insert plastic pin into each of the anchors and lightly tap to
activate anchor (see Figure 2). Remove pin and repeat on all anchors.
8. Remove mounting posts from the product assemblies by loosening each
setscrew.
9. One at a time, place each mounting post over anchors (notch facing downward)
and insert screws through post into anchors.
10. Tighten screws.
11. Assemble the towel bar and posts.
12. While assembled, position each end post with setscrews facing down and place
over both mounting posts. Tighten the setscrew at the bottom of each post.
Stock Number:_________________________Towel Bar
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
18” & 24” Towel Bar
DN7718 & DN7724
Lounge™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
25300 AL MOEN DRIVE NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321-8809 FAX: (800) 848-6636
INTERNATIONAL: (440) 962-2000 FAX: (440) 962-2726
CUSTOMER SERVICE (USA): 800-882-0116 FAX: (888) 379-2720
WWW.MOEN.COM
Copyright Creative Specialties International Literature #BA1314
-
1
