Directions below are for installation into drywall. If installing product into a stud,

use the wood screws only.

1) Remove mounting post from product assembly by loosening the setscrew.

2) Position the mounting post on the wall at desired location with notch facing

downward, and mark both vertical hole locations.

3) Drill 2 holes as marked using 5/16” drill bit.

4) Fold ends of the plastic toggle anchor together (see Figure 1) and insert into

each hole in the wall.

9) Place assembly over the mounting post with setscrew facing down and

tighten setscrew.

25300 AL MOEN DRIVE  NORTH OLMSTED, OH 44070

CORPORATE HEADQUARTERS: (800) 321-8809  FAX: (800) 848-6636

INTERNATIONAL: (440) 962-2000  FAX: (440) 962-2726

CUSTOMER SERVICE (USA): 800-882-0116  FAX: (888) 379-2720

WWW.MOEN.COM

Copyright Creative Specialties International Literature #BA1248