Directions below are for installation into drywall. If installing product into a stud, use
the wood screws only.
1. Remove mounting post from product assembly by loosening the setscrew.
2. Position the mounting post on the wall at desired location with notch facing
downward, and mark both horizontal hole locations.
3. Drill 2 holes as marked using 5/16” drill bit.
4. Fold ends of the plastic toggle anchor together and insert into each hole in the wall.
5. Lightly tap anchors until flush with the wall.
6. One at a time, insert plastic pin into each anchor and lightly tap to activate anchor.
Remove pin and repeat on other anchor.
7. Place mounting post over anchors with notch facing downward, and insert screws
through post into anchors.
8. Tighten screws.
9. Place assembly over the mounting post with setscrew facing down and tighten
setscrew.
25300 AL MOEN DRIVE NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321-8809 FAX: (800) 848-6636
INTERNATIONAL: (440) 962-2000 FAX: (440) 962-2726
CUSTOMER SERVICE (USA): 800-882-0116 FAX: (888) 379-2720
WWW.MOEN.COM
Copyright Creative Specialties International Literature #BA1242
Prime1
Towel Ring base is constructed of
zinc. Ring is brass.
DN0886ORB – Towel Ring
Oil Rubbed Bronze Finish
Cleaning Instructions:
Stock Number:______________________Towel Ring
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Towel Ring
DN0886
Gilcrest® Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
-
1
w innych językach
- English: Moen DN0886ORB Installation guide
Powiązane dokumenty
-
Moen DN2686BN Instrukcja obsługi
-
-
-
-
-
-
-
-
-