LED WORLD LIGHTING H-2102B instrukcja

Marka: LED WORLD LIGHTING

Model: H-2102B

Typ: instrukcja

HUEDA™ DMX512 Decoder (Indoor/Outdoor)

FEATURES

1/4

Model: H-2102B(W)

·Ensure applicable wire is installed between driver, xture, and any controls in between. When choosing wire, factor in voltage drop,

amperage rating and type (in-wall rated, wet location rated, etc.). Inadequate wire installation could overheat wires and cause re.

·This product is rated for indoor-outdoor installation and can be used for damp locations.

·Please check if the output voltage of any LED power supplies used comply with the working voltage of the product.

·This product is intended to be installed and serviced by a qualied licensed electrician. Install in accordance with the National

Electric Code, and local regulations. Disconnect power before installing or servicing. Only power with a regulated (listed)

constant voltage Class 2 power supply (12-24V DC). Never use this product with dimmable or magnetic dimmable

power source(driver).

·Do not modify this product beyond the instructions in this guide or the warranty will be voided.

·Wiring diagrams in this installation guide for basic installations. Please carefully review your installation before proceeding.

·Always be sure to mount this unit in an area with proper ventilation to avoid overheating.

·Never connect any cables while power is on and always assure correct connections to avoid short circuits before switching on.

·Please ensure that the cable is secured tightly in the connector

·For updated information please consult your supplier.

SAFETY & WARNINGS

BEFORE YOU BEGIN, READ ALL WARNINGS AND INSTALLATION INSTRUCTIONS (AS THEY MAY HAVE BEEN UPDATED FROM PREVIOUS VERSIONS ).

IMPROPER INSTALLATION(S) PRESENT HAZARDS, WHICH CAN RESULT IN PERSONAL INJURY OR PROPERTY DAMAGE.

PRODUCT PARAMETERS

Part No.

Input Voltage

Current

Output

H-2102B(W)

12V~36V DC

4 x 5A

4 x (60-180)W

Copyright © 2022 LED WORLD INC™. All Rights Reserved. We are not responsible for errors or omissions. Product and specications subject to change without notice. Registered trademarks are owned by their respective registers, or licensee(s).

LED World Inc. | #130 10615 48 ST SE | CALGARY, AB T2C 2B7 | CANADA | Version 2.2 12/22/22

1-800-387-4081

ledworldlighting.com ledworld.ca |

·Three-channel/ four-channel output selectable

·Standard DMX512 compliant control interface, Congurable DMX address with Via digital numeric display

·IP67 Indoor/Outdoor use (water resistant)

·Compatible with Standard DMX Master and HUEDA™ DMX Controller

Years

Limited Manufacturer

Warranty

WIRING DIAGRAM

H-2102B(W)

DMX5 12 D ecoder

Line Co lor

H-2102B(W)

DMX5 12 D ecoder

Line Co lor

H-2102B(W)

DMX5 12 D ecoder

Line Co lor

Line 1

Line 2

DMX

Input

Power

Input

DMX

Outpu t

Power

Input

Line 1

Line 2

DMX

Input

Power

Input

DMX

Outpu t

Power

Input

Line 1

Line 2

DMX

Input

Power

Input

DMX

Outpu t

Power

Input

RGBW LED Strip

DMX Master Controller

D- GNDGND D+Vin

H-2102B(W)

DMX512 Decoder

Line Color

Line 1

Line 2

DMX

Input

Power

Input

DMX

Output

Power

Input

Line 1

Line 2

DMX Input

Power Input

DMX Output

Power Input

Black : V-

Red : V+

Green : D-

Yellow : GND

White : D+

Black : V-

Red : V+

Green : D-

Yellow : GND

White : D+

RGBW Output

Black : +

Red : R

Green : G

Yellow : B

White : W

PRODUCT WIRE OVERVIEW

AC Power

50/60Hz

V+

V-

Class 2 Regulated Driver

(12~24VDC)

AC Power

50/60Hz

V+

V-

Class 2 Regulated Driver

(12~24VDC)

AC Power

50/60Hz

V+

V-

Class 2 Regulated Driver

(12~24VDC)

Securely mount with screw to surface

Make connection of LED Strip to RGBW Controller in a

weather proof box

Make sure that

wires cannot

cross

Make sure that

wires are fully inserted

wrong correct

(Red Wire)

(Black Wire)

(Red Wire)

(Black Wire)

(Red Wire)

(Black Wire)

Line 1

Line 2

Line 1

Line 2

Line 1

Line 2

Zone 1 DMX Channel 1

Zone 2 DMX Channel 5

Zone 3 DMX Channel 9

DMX In

Power In

V-

Black

Red

Green

Yellow

White

V+ D- GND D+

DMX Out

Power In

V-

Black

Red

Green

Yellow

White

V+ D- GND D+

Line 1

Line 2

RGBW Output

Black

Red

Green

Yellow

White

R G B W

Note: Wire color for white

in RGBW Strip may vary

Black :V-

Yellow :GND

Green :D-

White :D+

Red :V+

Green :D-

Black :V-

White :D+

Yellow :GND

Red :V+

Red :R-

Green :G-

Black :V-

Yellow :B-

White :W+

Black :V-

Green :D-

Yellow :GND

Red :V+

Black :V-

Red :R-

Yellow :B-

White :W+

Green :G-

Black :V-

Red :V+

Green :D-

Yellow :GND

White :W+

Red :R-

Green :G-

Yellow :B-

Black :V-

Red :V+

Black :V-

Green :D-

Yellow :GND

Red :V+

Green :D-

Black :V-

Red :V+

Yellow :GND

Green :D-

Yellow :GND

Red :V+

Black :V-

Green :D-

Green :G-

Black :V-

Red :R-

Yellow :B-

White :W+

HUEDA™ DMX512 Decoder (Indoor/Outdoor)

Model: H-2102B(W) 1-800-387-4081

ledworldlighting.com ledworld.ca |

2/4 Copyright © 2022 LED WORLD INC™. All Rights Reserved. We are not responsible for errors or omissions. Product and specications subject to change without notice. Registered trademarks are owned by their respective registers, or licensee(s).

LED World Inc. | #130 10615 48 ST SE | CALGARY, AB T2C 2B7 | CANADA | Version 2.2 12/22/22

PRODUCT INSTRUCTIONS

Through buttons to set desired DMX512 address, 1 key is to set “hundreds” position, 2 is to set “ten” position, 3 is to set “zero”

position.

Operation

“1" button

“2" button

“3" button

To open the connection of DMX512 controller, then it can work correctly.

Set DMX address

Press 1st button for 2 seconds, digital display flashes to set the required DMX address, then press any button for >2 seconds to

confirm.

Press 2nd button and 3rd button at the same time for 2 seconds, cH digital display flashes, then press 1st button to choose

1/2/3/4, 3 means total 3 channels, 4 means total 4 channels. Press any button for >2 seconds to confirm the 1,2,3 or 4 channels.

The factory preset default is 4 channels outputs. Hence at factory reset default to RGB LED Strip.

Choose Channel (optional)

P means PWM frequency, press 1st to show "1", means 1500Hz, "2" means 200Hz.

The factory preset default is PWM frequency 200Hz with linear dimming. 2-2

Press 1st button and 3rd button for 2 seconds, digital display flashes to show P-c.

c means dimming options, press 3rd to show "1", means logarithmic dimming, "2" means linear dimming.

Choose PWM frequency (optional)

PRODUCT DIMENSION

170mm (6.69”)

180.5mm (7.10”)

73.6mm (2.89”)

38mm (1.49”)

HUEDA™ DMX512 Decoder (Indoor/Outdoor)

Model: H-2102B(W) 1-800-387-4081

ledworldlighting.com ledworld.ca |

3/4 Copyright © 2022 LED WORLD INC™. All Rights Reserved. We are not responsible for errors or omissions. Product and specications subject to change without notice. Registered trademarks are owned by their respective registers, or licensee(s).

LED World Inc. | #130 10615 48 ST SE | CALGARY, AB T2C 2B7 | CANADA | Version 2.2 12/22/22

FEDERAL COMMUNICATIONS COMMISSION (FCC) STATEMENT

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may cause undesired operation.

Note: The manufactures is not responsible for any radio or tv interference caused by unauthorized modications to this equipment. Such

modications will void the user's authority to operate the equipment and warranty.

THREE YEAR LIMITED WARRANTY

LED WORLD INC. warranties this product for three year (some exceptions may apply) from the date of shipping unless otherwise noted in writing.

This warranty is expressly in lieu of all other warranties expressed or implied. Under this Limited Warranty, the obligation of the company is limited to

replacing on a prorated basis, at its option, any component found to be defective. This Limited Warranty does not apply to damage caused by buyer

or alteration to the product or incorrect power supply. Factory warrantees are covered by the original manufacturer and claims must be submitted to

them. Use only with LED World’s regulated class 2 power supply.

LED World Inc. And its providers will never be liable to you or any other person for any indirect, incidental, consequential, special, punitive or

exemplary loss or damage arising from, connected with, the purchase of products, including but not limited to loss of data, business, markets, cost

of labour, savings, income, profits, use, production, reputation or goodwill, anticipated or otherwise, or economic loss, under any theory of liability

(whether in contract, tort, strict liability or any other theory or law or equity), regardless of any negligence or other fault or wrongdoing (including

without limitation gross negligence and fundamental breach) by led world inc. Or any person for whom led world inc. Is responsible, and even if led

world inc. Has been advised of the possibility of such loss or damage being incurred.

If a product is defective, we will replace the product with similar or identical product or at our option a credit towards a future purchase. To make a

claim under this warranty, obtain a return authorization number.

HUEDA™ DMX512 Decoder (Indoor/Outdoor)

Model: H-2102B(W) 1-800-387-4081

ledworldlighting.com ledworld.ca |

4/4 Copyright © 2022 LED WORLD INC™. All Rights Reserved. We are not responsible for errors or omissions. Product and specications subject to change without notice. Registered trademarks are owned by their respective registers, or licensee(s).

LED World Inc. | #130 10615 48 ST SE | CALGARY, AB T2C 2B7 | CANADA | Version 2.2 12/22/22