Please keep this User Manual for future
consultation. If you sell the xture to another
user, be sure that they also receive this
instruction booklet.
Unpack and check carefully there is no
transportation damage before using the xture.
Before operating, ensure that the voltage and
frequency of power supply match the power
requirements of the xture.
It’s important to ground the yellow/green
conductor to earth in order to avoid electric
shock.
Disconnect main power before servicing and
maintenance.
Use safety chain when xes this xture. Don’t
handle the xture by taking its head only, but
always by taking its base.
Maximum ambient temperature is: 40°C Don’t
operate it where the temperature is higher than
this.
WARNING! The Led Moving Head (LMH) has a powerful pan motor. The torque reaction when
the head is panned suddenly can cause the base to move if the fixture is standing unsecured on
a surface. Do not apply power to the LMH unless the baase is securely fastened to a surface or to
rigging hardware.
WARNING! Use 2 clamps to rig the fixture. Do not hang the fixture from only one clamp. Lock
each clamp with both 1/4-turn fasteners. Fasteners are locked only when turned a full 90 clockwise.
WARNING! When clamping the fixture to a truss or other structure at any other angle than with
the yoke hanging vertically downwards, use two clamps of half-coupler type. Do not use any type of
clamp that does not completely encircle the structure when fastened.
WARNING! Position or shade the head so that the front lens will not be exposed to sunlight or any
other strong light source from any angle - even for a few seconds. See Figure 1. The LMH lens
can focused the sun's rays, creating a potential fire hazard and causing damage.
IMPORTANT! Do not point strong light output from other fixtures at the LMH, as intense
illumination can damaged the display.
In the event of serious operating problem,
stop using the xture immediately. Never try
to repair the xture by yourself. Repairs carried
out by unskilled people can lead to damage
or malfunction. Please contact the nearest
authorized technical assistance center. Always
use the same type spare parts.
Do not connect the device to any dimmer
pack.
Do not touch any wire during operation and
there might be a hazard of electric shock.
To prevent or reduce the risk of electrical
shock or re, do not expose the xture to rain
or moisture.
The housing must be replaced if they are
visibly damaged.
Do not look directly at the 10R light spot while
the xture is on.
2. SAFETY INFORMATION
1. INTRODUCTION
THANK YOU FOR PURCHASING ART WASH FX. FOR SAFETY REASONS AND TO ENSURE
THE TROUBLE-FREE OPERATION, CAREFULLY READ THE INSTRUCTIONS.
User Manual • Instrukcja Obsługi
Figure 1. Lenses can focused sunlight and strong light, presenting a risk of fire and damage to the fixture.
Shield or shade the head if necessary.
WARNING