Silvercrest Z31370B Operation and Safety Notes

Wireless Doorbell

Operation and Safety Notes

bezDrátový zvonek

Pokyny pro obsluhu a bezpečnostní pokyny

Funktürklingel

Bedienungs- und Sicherheitshinweise

DzWonek Do DrzWi

steroWany raDioWo

Wskazówki dotyczące obsługi i bezpieczeństwa

brezžični zvonec

Navodila za upravljanje in varnostna opozorila

zvonček na Dvere

Pokyny pre obsluhu a bezpečnostné pokyny

Z31370A

Z31370B

GB Operation and Safety Notes Page 7

PL Wskazówki dotyczące obsługi i bezpieczeństwa Strona 20

SI Navodila za upravljanje in varnostna opozorila Stran 32

CZ Pokyny pro obsluhu a bezpečnostní pokyny Strana 46

SK Pokyny pre obsluhu a bezpečnostné pokyny Strana 58

DE / AT / CH Bedienungs- und Sicherheitshinweise Seite 70

3

Z31370A Z31370B

A

1

6

2

3

ø 6 mm

4

8

7

5

You need

Potrzebujecie

Potrebujete

Potřebujete

Budete potrebovať

Sie benötigen:

4

B

910

5

D

C

15

13 11 12

14

6

E

16 17

F

18

16

17

GB 7

Introduction

Intended use ........................................................................................... Page 8

Technical data ........................................................................................ Page 8

Included items ........................................................................................ Page 9

Parts and features .................................................................................. Page 9

Safety .................................................................................................... Page 10

General safety information ...................................................................Pag e 11

Safety instructions for batteries ............................................................ Page 12

Assembly ............................................................................................Page 13

Preparing for use

Inserting / replacing the batteries .........................................................Page 13

Operation

Synchronising transmitter / receiver ..................................................... Page 15

Setting the signal type ........................................................................... Page 15

Setting the volume ................................................................................. Page 16

Selecting the chime ................................................................................ Page 16

Troubleshooting ...................................................................................... Page 16

Cleaning and maintenance ............................................... Page 17

Disposal ............................................................................................... Page 17

Information

Declaration of conformity ..................................................................... Page 19

Table of Contents

GB8

Introduction

Wireless Doorbell

Introduction

Keep these instructions in a safe place. If you pass the product

on to anyone else, please ensure that you also pass on all

the documentation.

Intended use

This product is intended for the wireless transmission of the doorbell

chime. The product is not intended for commercial use.

Technical data

Range: 100 m (unobstructed area)

Transmission frequency: 433 MHz

Battery types: Receiver: 2 x 1.5 V

(type AA / LR6),

Transmitter: 1 x 3 V

(type CR2032)

Receiver: Audible signal volume (at maximum volume

setting): min. 73 dB (at a distance of 1 m

from the device)

Transmitter: IP rating: IP44

GB 9

Introduction

Included items

1 Transmitter

1 Receiver

2 Batteries 1.5 V

, type AA (receiver)

1 Batteries 3 V

, type CR2032 (transmitter)

4 Screws (for transmitter and for mounting the receiver on a wall)

3 Dowels

5 Exchangeable name plates (for the doorbell)

1 Doorbell cover

1 Operating instructions

Parts and features

Receiver (Figs. A / B):

1

Signal indicator

2

Synchronisation button

3

Volume button

4

Melody selection button

5

Signal type selector button (optical, acoustic, optical and acoustic

signal)

6

Speaker

7

Stand

8

Hanger

9

Battery compartment cover

10

Battery compartment

GB10

Introduction / Safety

Transmitter (Figs. C / D):

11

Signal indicator

12

Name plate

13

Chime button

14

Battery compartment

15

Holder (for wall mounting)

Mounting (Figs. E / F):

16

Screw

17

Dowel

18

Screw (for transmitter)

Safety

Read all safety information and instructions. Failure

to comply with the safety information and instructions may cause ﬁre

and / or serious injury.

YOU SHOULD STORE ALL SAFETY INFORMATION AND INSTRUC-

TIONS IN A SAFE PLACE IN CASE YOU NEED TO REFER TO THEM

AGAIN IN THE FUTURE!

GB 11

Safety

General safety information

Children often underestimate risks.

Always keep children away from the product. This is not

a toy.

Children or persons who lack the knowledge or experience to use

the device or whose physical, sensory or intellectual capacities are

limited must never be allowed to use the device without supervision

or instruction by a person responsible for their safety. Children must

never be allowed to play with the device.

Check that all parts are in sound condition. If you use damaged

parts when assembling the device, you risk injury.

Check that all parts have been assembled correctly. There is a risk

of injury if the device is not properly assembled.

Keep the device away from open ﬂames or sources of heat (e.g.

burning candles).

GB12

Safety

Safety instructions for batteries

DANGER TO LIFE! Batteries can be swallowed,

which can prove fatal. Consult a doctor immediately if anyone

swallows a battery.

EXPLOSION HAZARD! Never recharge nonrecharge-

able batteries, short-circuit and / or open batteries. This can

cause them to overheat, burn or burst.

Never throw batteries into ﬁre or water. The batteries may explode.

Immediately remove depleted batteries from the device; otherwise

there will be an increased risk of leakage!

Always replace all the batteries at the same time and insert batteries

of the same type.

Do not use diﬀerent types of batteries or mix used and new batter-

ies together.

Batteries do not belong in household refuse. Dispose of used batteries

in an environmentally friendly manner.

Consumers are under a legal obligation to dispose of batteries in

the proper way.

Keep the battery out of the reach of children, do not dispose of the

battery in ﬁre, do not short-circuit it, and do not take it apart.

Failure to observe these instructions may result in the battery discharging

beyond its end voltage, which poses a risk of leakage. If the battery

in your instrument has leaked, have it removed immediately to prevent

damage to the instrument.

GB 13

Safety / Assembly / Preparing for use

Avoid contact with skin, eyes and mucous membrane. In the event of

contact with battery acid, rinse the aﬀected area with plenty of water

and / or consult a doctor.

Never use rechargeable batteries.

The supply terminals are not to be short-circuited.

Do not mix old batteries with new ones.

Remove the batteries from the device if they have not been used for

a long period.

Make sure you insert the batteries the right way round (polarity).

Assembly

Note: You will need a screwdriver and a drill to assemble the doorbell.

Note: Only use the screws and dowels supplied for the assembly of

the device.

Mount the receiver (see Fig. E)

Mount the transmitter (see Fig. F)

Preparing for use

Inserting / replacing the batteries

Insert the batteries to provide power to the device before preparing

it for use.

GB14

Preparing for use

CAUTION! Use the above-indicated battery types only. Failure to

observe this advice may result in damage to the product.

Receiver:

Remove the battery compartment cover

9

from the back of the

device.

Remove the used batteries, if present.

Insert 2 batteries (1.5 V , type AA).

Note: Ensure correct polarity. This is indicated in the battery

compartment

10

.

Close the battery compartment

10

.

Transmitter:

Remove the holder

15

from the back of the transmitter.

Remove the used batteries, if present.

Insert a battery (3 V , type CR 2032). The side marked “+” must

face upwards.

Fasten the holder

15

of the receiver back on to the back of the device.

GB 15

Operation

Synchronising transmitter / receiver

Synchronise the transmitter and receiver as follows:

As soon as the batteries are installed, the receiver enters synchronis-

ing mode.

You can also manually enter synchronising mode by holding the

synchronising button

2

for approx. 3 seconds.

The signal indicator

1

on the receiver will light on.

Press the chime button

13

, the signal indicator

11

on the transmitter

will illuminate once.

The signal indicator

1

on the receiver will then blink. This is to indi-

cate the synchronisation is successful.

NOTE: The synchronisation mode can only last for approx. 2 minute. If

you cannot synchronise your transmitter and receiver, please enter syn-

chronising mode again.

Setting the signal type

The receiver can indicate the reception of a door signal either optically

or acoustically or both optically and acoustically.

GB16

Operation

Using the signal type selector button

5

, select whether the signal

is to be indicated optically or acoustically or both optically and

acoustically.

Setting the volume

Press the volume button

3

until the desired volume is reached. There

are a total of 4 possible volume settings: very loud, loud, medium,

soft.

Selecting the chime

Note: The doorbell has 36 diﬀerent chimes.

Press the melody selection button

4

. The ﬁrst audible signal sounds.

Press the melody selection button

4

again to move on to the next

audible signal.

Repeat this process until you have selected your desired audible signal.

The last-selected audible signal is automatically stored.

Troubleshooting

After the inﬂuence of extraordinary environmental conditions (e.g. a strong

electromagnetical ﬁeld) the function of the item may be aﬀected. In this

case, please take oﬀ the batteries of both appliances for approximately

GB 17

Operation / Cleaning and maintenance / Disposal

2 minutes. Then proceed again as described in the section “Synchronising

the transmitter / receiver”.

Electrostatic discharges may lead to malfunctions. If such malfunctions

do occur, remove the battery for a short time and then replace it again.

Then proceed again as described in the section “Synchronising the

transmitter / receiver”.

Cleaning and maintenance

Under no circumstances should you use liquids or detergents, as

these will damage the device.

The device should only be cleaned on the outside with a soft dry cloth.

Disposal

The packaging is made entirely of recyclable materials,

which you may dispose of at local recycling facilities.

Contact your local refuse disposal authority for more details of how to

dispose of your worn-out product.

GB18

Disposal

To help protect the environment, please dispose of the product

properly when it has reached the end of its useful life and not

in the household waste. Information on collection points and

their opening hours can be obtained from your local authority.

Faulty or used batteries must be recycled in accordance with Directive

2006 / 66 / EC. Please return the batteries and / or the device to the

available collection points.

Pb

Environmental damage through

incorrect disposal of the batteries!

Batteries may not be disposed of with the usual domestic waste. They

may contain toxic heavy metals and are subject to hazardous waste

treatment rules and regulations. The chemical symbols for heavy metals

are as follows: Cd = cadmium, Hg = mercury, Pb = lead. That is why

you should dispose of used batteries at a local collection point.

GB 19

Information

Declaration of conformity

We, OWIM GmbH & Co. KG, Stiftsbergstraße 1, D-74167 Neckarsulm,

hereby declare under our sole responsibility that the product: Wireless

Doorbell, Model No.: Z31370A / Z31370B, Version: 01 / 2013, to

which this declaration refers, complies with the standards / normative

documents of 1999 / 5 / EC.

The complete declaration of conformity can be viewed at:

www.owim.com.

EMC

PL20

Wstęp

Zastosowanie zgodne z przeznaczeniem .......................................Strona 21

Parametry techniczne ......................................................................... Strona 21

Zakres dostawy ...................................................................................Strona 22

Przegląd części ...................................................................................Strona 22

Bezpieczeństwo ........................................................................ Strona 23

Wskazówki ogólne dotyczące bezpieczeństwa .............................Strona 24

Wskazówki bezpieczeństwa dotyczące baterii .............................. Strona 24

Montaż ..............................................................................................Strona 26

Uruchomienie

Zakładanie / wymiana baterii ...........................................................Strona 26

Obsługa

Synchronizacja nadajnika / odbiornika ............................................Strona 27

Ustawianie rodzaju sygnału .............................................................. Strona 28

Ustawianie głośności ..........................................................................Strona 28

Wybór dźwięku dzwonka ................................................................. Strona 28

Usuwanie błędów ...............................................................................Strona 29

Czyszczenie oraz pielęgnacja .....................................Strona 29

Usuwanie ........................................................................................Strona 30

Informacje

Deklaracja zgodności ........................................................................ Strona 31

Spis zawartości

Strona jest ładowana ...

Silvercrest Z31370B Operation and Safety Notes

Ten podręcznik jest również odpowiedni dla

Silvercrest Z31370B Operation and Safety Notes

w innych językach

Powiązane dokumenty

Inne dokumenty