INSTALLATION & MAINTENANCE GUIDE
–4–
www.amplighting.com
–4–
2
1
AMP
®
Sol Box
ASDL-2014-P-BK
Test Solar Light
Press the ON/OFF switch on
the back of the xture body.
Place the solar light on a
non-abrasive surface with
the solar panel against the
surface to test the xture.
There will be a short delay
for the xture to light up.
The xture will light up when
the solar panel is covered
and turn back off when it is
uncovered.
Now you can proceed to next
steps of installations knowing
the xture is in ON mode.
On/Off Switch
Fixture Body
Non-abrasive Surface
Install Mounting Bracket
1. Place the mounting bracket onto
the desired location and mark two
points on the wall for the wall
anchors.
2. Remove the mounting bracket. Drill
the proper holes on the marks for
the wall anchors by using an elec-
trical drill.
3. Push the wall anchors into the
drilled holes.
4. Attach the mounting bracket onto
the wall anchors and secure with
the screws. Tighten until snug with
a screwdriver.
WALL SURFACE
Mounting
Bracket
Screw
Wall Anchor
Hole
NOTE: These deck lights need to be mounted in a place where
there is plenty of sunlight.