Please download the latest
CamView software at this address :
http://www.starvedia.com/download.html
After the setup menu pops up, select
“Install Management Software” and follow
the instructions.
The CamView software will list
the searched camera on the
“Auto search” section
Drag the camera from the“Auto
Search” section to the “Camera
List” section.
Right click the camera on
the camera list and choose
the ID/Password Settings.
Key-in the password given on
the ID/Password Card and then
you will be able to see the video.
Enable SD card recording.
Always Recording
When disk space full
SD-Card Status SD-Card Removed
Save & Apply
Schedule Recording
Circular recording
Stop recording
Standby
SD-Card Record Setting
SD Card Record Settings on the Web
configuration page. Then select “schedule
recording” and the SD card recording will
be operational right after saving.
What should I do if I have forgotten the password or the ID/Password card is missing?
Please press the Reset button for five seconds. The camera will reset to the factory
default settings. The default video-play password is ipcam (lowercase).
Q1
Ans
What should I do if I cannot see the video remotely?
The red LED of the camera should be remain on when the camera is connected to
the Internet. If the red LED is blinking, please double check the network connection
and settings again.
Q2
Ans
I can see the video from a remote location, but the video quality is not satisfying and
sometimes the video disconnects and reconnects by itself.
It’s probably due to the poor Internet bandwidth (internet speed), which might be
not good enough.
You may try to apply for a better Internet connection from your Internet Service
Provider or reduce the bandwidth setting of the camera.
Q3
Ans
What is the default admin user name/password?
Default admin user name: admin
Default admin password: (leave blank)
Q4
Ans
Please refer to the following website to download the latest CamView software.
www.starvedia.com/download.html
Q5
Ans
Where to download the latest camView software?
[ FRONT ] [ BOTTOM ]
Camera ID/Password Card QIG
Full HD Outdoor IP Camera
Anchors
and Screws
Power Adapter
Ethernet Cable Splitter Cable
Installation CD
RJ45 Coupler
Quick Installation GuideFull HD Outdoor IP Network Camera
SD Card Playback. Right Click on the
selected camera on the camera list,
then choose the SD card playback.
Screw size: 3.5 x 16mm
Microphone
Power + Ethernet Jack
MicroSD Card Slot WPS Button
Reset Button