De La Espada 392 Instrukcja instalacji

Marka
De La Espada
Model
392
Typ
Instrukcja instalacji
0
1
M
A
T
T
H
E
W
H
I
L
T
O
N
PARTS
1x Mirror
1x Timber wall bracket
HARDWARE
(5x) M5x60 pozidrive screws
(5x) M8x50 wall plug / Rawlplug / anchor
NOTE: It is important to use the correct wall plug for your
wall type.
YOU WILL NEED
Cordless drill
8mm drill bit
Philips head screwdriver
The help of a friend
NOTES
NOTE 1: Be certain that all assembly is carried out on a at
and stable surface. This will ensure a good nal result.
Reverse the steps to disassemble the piece.
NOTE 2: Your furniture arrives packed in numerous layers that
protect it during transport. It is important that you remove
the packaging carefully to avoid damaging your furniture. Refer
to our information sheet “Unpacking Your Furniture” for further
details.
NOTE 3: Great care is required when assembling our products.
Use blankets to soften the assembly surface - hard surfaces
such as wood or stone ooring may damage the furniture if in
direct contact.
NOTE 4: We advise that assembly and disassembly of De La Espada
furniture is undertaken by a minimum of 2 people.
INSTALLATION INSTRUCTIONS
CONISTON MIRROR BY MATTHEW HILTON
These instructions apply to all Coniston Mirrors
SALES@DELAESPADA.CO M
DELAESPADA.COM
0
2
M
A
T
T
H
E
W
H
I
L
T
O
N
ASSEMBLY INSTRUCTIONS CONTINUED
CONISTON MIRROR
SALES@DELAESPADA.CO M
DELAESPADA.COM
1) ATTACH TIMBER WALL BRACKET TO WALL
a) Hold the wall bracket against the wall where you wish to
hang the mirror. Use a leveller to make sure the bracket is
level. NOTE: The taller side of the bracket should be away from
the wall.
b) Use a pencil to mark the wall where holes should be drilled.
c) Using a cordless drill and an 8mm drill bit, drill holes
into the wall where you have marked.
d) Place the wallplugs into the drilled holes in the wall.
Then, using a Philips head screwdriver, screw a pozidrive screw
through each pre-drilled hole in the timber wall bracket and
into the corresponding hole in the wall. Tighten rmly.
0
3
M
A
T
T
H
E
W
H
I
L
T
O
N
ASSEMBLY INSTRUCTIONS CONTINUED
CONISTON MIRROR
SALES@DELAESPADA.CO M
DELAESPADA.COM
2) HANG MIRROR ONTO TIMBER WALL BRACKET
a) Fix the mirror to the wall by sliding the brace on the back
of the mirror onto the wall mounted bracket.
0
4
M
A
T
T
H
E
W
H
I
L
T
O
N
ASSEMBLY INSTRUCTIONS CONTINUED
CONISTON MIRROR
SALES@DELAESPADA.CO M
DELAESPADA.COM
b) Installation is now complete.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

De La Espada 392 Instrukcja instalacji

Marka
De La Espada
Model
392
Typ
Instrukcja instalacji
ściągnij PDF
raport

w innych językach

Inne dokumenty