Williams 96 LED Series Instrukcja instalacji

Typ
Instrukcja instalacji
96 & 97 LED SERIES
INSTALLATION INSTRUCTIONS
H.E. Williams, Inc. Carthage, Missouri www.hew.com 417-358-4065
Page 1 of 2
PN 4909017403/16/16JL
WARNING:
This product must be installed in accordance with the applicable
installation code by a person familiar with the construction and
operation of the product and the hazards involved.
Make sure all electrical power is turned off while installing the fixture.
This luminaire must be adequately grounded for protection against
shock hazards and to assure proper operation.
Disconnect power before servicing.
LEDs are ESD (Electro Static Discharge) sensitive devices that can be
easily damaged if the proper ESD mitigating steps are not taken.
LEDs are very sensitive to mechanical damage. Caution must be taken
to avoid damage to the LEDs.
ESD or mechanical damage voids all warranties.
FIXTURE DETAIL
Use the illustrations below when assembling or disassembling the fixture. (96, 4’ shown)
Latch
Mounting bracket
Wireway cover
Lens
F
iberglass housing
End plug
BACKVIEW
B
A
Nominal
Length
Overall
Length (A)
Mounting
Distance (B)
2’ 27-5/8” 12”- 17” OC
4’ 51-7/8 30”- 42” OC
8’ 100-1/4 48”- 80” OC
96 & 97 LED SERIES INSTALLATION INSTRUCTIONS
H.E. Williams, Inc. Carthage, Missouri www.hew.com 417-358-4065
Page 2 of 2
PN 49090174
INSTALLATION
Step 1: Securely attach mounting brackets (2) to mounting surface.
The 96/97 enclosure will engage the mounting brackets
at any point along itslength, except for where there are
latches. Required spacing between the brackets are as
follows: 12” - 17” for 2’ housings, 30” - 42” for 4’ housings,
and 48”- 80” for 8’ housings.
Step 2: Insert one side of the 96/97 housing into the mounting
brackets.
Step 3: Push up on the enclosure and then press in on the
mounting bracket until the mounting bracket clicks into
place.
Step 4: Verify that the enclosure is fully supported before
connecting to a power supply.
  • Page 1 1
  • Page 2 2

Williams 96 LED Series Instrukcja instalacji

Typ
Instrukcja instalacji

w innych językach