1. Connect the RS232 cable between the gateway and a PC and then switch on the gateway.
2. Start a terminal program on the PC and configure it to: 9600, 8, 1, None.
3a. To assign a static IP-address, type ‘ipassign static’ and ‘ipaddress <static IP-address>’.
3b. To assign an IP Subnetmask, type ‘ipaddress subnetmask <subnetmask>’.
3c. To assign an IP Gateway address, type ‘ipaddress gateway <gateway IP-address>’.
4. Restart the gateway.
Front Panel
Rear Panel
Configuration
TIP
DHCP ASSIGNED IP-ADDRESSES ARE SUPPORTED BY THE TANDBERG GATEWAY (FACTORY DEFAULT).
5. Start a WEB browser and enter the IP-address of the gateway. Default password: ‘TANDBERG’.
6. To configure the gateway for ISDN dial in, enter PRI numbers and dial in number(s). For details,
see the ‘PRI Configuration’ and the ‘ISDN Dial in configuration’ section in the User Manual.
7. To configure the gateway for IP dial in, enter H.323 services and register the gateway to a
gatekeeper. For details, see ‘H.323 Services’ and ‘H.323 Configuration’ in the User Manual.
I
o
LAN 1 LAN 2 PRI 1 PRI 2 PRI 3 PRI 4 RS 232
G
reen:
Layer 1 O
K
Red:
D-Channel Down
Red:
Layer 1 Red Alarm
Yellow
:
Layer 1 Yellow Alarm
G
reen:
Layer 1 O
K
Red:
D-Channel Down
Red:
Layer 1 Red Alarm
Yellow
:
Layer 1 Yellow Alarm
G
reen:
Layer 1 O
K
Red:
D-Channel Down
Red:
Layer 1 Red Alarm
Yellow
:
Layer 1 Yellow Alarm
G
reen:
Layer 1 O
K
Red:
D-Channel Down
Red:
Layer 1 Red Alarm
Yellow
:
Layer 1 Yellow Alarm
Green:
Tx
G
reen:
Rx
Green:
Tx
G
reen:
Rx
Green:
Not in use
G
reen:
Pow
er on
G
reen:
Not in use
Green:
Not in use
GW