Moen DN0786BN Instrukcja obsługi

Typ
Instrukcja obsługi
25300 AL MOEN DRIVE NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321-8809 FAX: (800) 848-6636
INTERNATIONAL: (440) 962-2000 FAX: (440) 962-2726
CUSTOMER SERVICE (USA): 800-882-0116 FAX: (888) 379-2720
WWW.MOEN.COM
Copyright Creative Specialties International
Directions below are for installation into drywall. If installing product into a stud, use
the wood screws and washers provided only.
1. Remove mounting posts from the product assemblies by loosening each setscrew.
2. Position the mounting plate on the wall at desired location with UP” facing you. Mark hole
locations.
3. Drill two holes as marked using a 5/16drill bit.
4. Fold ends of the plastic toggle together and insert into each hole in the wall.
5. Lightly tap anchors until flush with the wall.
6. One at a time, insert plastic pin into each of the anchors and lightly tap to activate anchor.
Remove pin and repeat on the other anchor.
7. Place the mounting plate on the wall over the installed wall anchors with “UP facing you.
8. Tighten screws.
9. Place decorative product over the mounting plate with the setscrew facing down. Tighten
setscrew.
Towel Ring post is constructed of
zinc. Ring is aluminum.
DN0786CH Towel Ring
Chrome Finish
DN0786BN Towel Ring
Brushed Nickel Finish
Cleaning Instructions:
Stock Number:______________________Towel Ring
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
DN0786
Iso Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
Literature #BA1403
  • Page 1 1

Moen DN0786BN Instrukcja obsługi

Typ
Instrukcja obsługi

w innych językach