Moen DN2603BN Instrukcja obsługi

Typ
Instrukcja obsługi

Ten podręcznik jest również odpowiedni dla

Directions below are for installation into drywall. If installing product into a stud,
use the wood screws only.
1) Remove mounting post from product assembly by loosening the setscrew.
2) Position the mounting post on the wall at desired location w ith notch facing
downward, and mark both vertical hole locations.
3) Drill 2 holes as marked using 5/16” drill bit.
4) Fold ends of the plastic toggle anchor together (see Figure 1) and insert into
each hole in the wall.
5) Lightly tap anchors until flush with the wall.
6) One at a time, insert plastic pin into each anchor and lightly tap to activate
anchor. Remove pin and repeat on other anchor.
7) Place mounting post over anchors (with UP facing you) and insert screws
through post into anchors.
8) Tighten screws.
9) Place assembly over the mounting post with setscrew facing down and
tighten setscrew.
25300 AL MOEN DRIVE NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321-8809 FAX: (800) 848-6636
INTERNATIONAL: (440) 962-2000 FAX: (440) 962-2726
CUSTOMER SERVICE (USA): 800-882-0116 FAX: (888) 379-2720
WWW.MOEN.COM
Copyright Creative Specialties International Literature #BA1245
Robe Hook is constructed of zinc.
DN2603BN Robe Hook
Brushed Nickel Finish
DN2603CH Robe Hook
Chrome Finish
Cleaning Instructions:
Stock Number:______________________Robe Hook
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Robe Hook
DN2603
Glenshire® Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
  • Page 1 1

Moen DN2603BN Instrukcja obsługi

Typ
Instrukcja obsługi
Ten podręcznik jest również odpowiedni dla

w innych językach