User Manual
Instrukcja Obsługi
F7300250
BIG LOGO PROJECTOR
IP65 300W
User Manual •Instrukcja Obsługi
Please keep this User Manual for future
another user, be sure that they also receive
this instruction booklet.
Unpack and check carefully there is no
transportation damage before using the
Before operating, ensure that the voltage
and frequency of power supply match the
It’s important to ground the yellow/green
conductor to earth in order to avoid electric
shock.
Disconnect main power before servicing
and maintenance.
only, but always by taking its base.
IMPORTANT!
at the BIG LOGO PROJECTOR, as intense
illumination can damaged the display.
Don’t operate it where the temperature is
higher than this.
In the event of serious operating problem,
carried out by unskilled people can lead to
damage or malfunction. Please contact the
nearest authorized technical assistance
center. Always use the same type spare
parts.
Do not connect the device to any dimmer
pack.
Do not touch any wire during operation
and there might be a hazard of electric
shock.
To prevent or reduce the risk of electrical
rain or moisture.
visibly damaged.
Do not look directly at the LED light spot
2. SAFETY INFORMATION
1. INTRODUCTION
BIG LOGO PROJECTOR IP65 300W
WARNING!
Figure 2.
BIG LOGO PROJECTOR IP65 300W • Art No F7300250
holes on the bracket. Always ensure that
and slipping while operating. Always
ensure that the structure to which you are
attaching the unit is secure and is able to
5.1 Connecting DMX signal
4. INSTALLATION
5. CONNECTION
3. PRODUCT INFORMATION
weight. Also always use a safety cable that
can hold 12 times of the weight of the unit
of people and has no one pass by or under
it.
1
3
22
FEMALE
XLR
GROUND
DMX +
DMX -
MALE
XLR
3
1
CAUTION!
DMX signal has to be terminated with a
DMX
Controller DMX 512 DMX 512
1
FEMALE
XLR
GROUND
DMX +
DMX -
MALE
XLR
2
3
4
5
1
2
3
45
Light source: 1pcs 300W LED
Signal: DMX 512
The connection is performed using
(included). The device must be
operated by qualified personnel.
5.2 Voltage specification
Input Voltage Total Power Frequency
110-240V 300W 50/60Hz
5.3 Connecting power supply
CAUTION! In the case of cable damage do not attempt to repair.
a person with appropriate permissions.
Make sure that the power grid supply
parameters are consistent with device
parameters and limitations are not
---- Run Mode
---- Scene Run
---- Scene Set
---- DMX Address
---- Channel Mode
---- DMX signal
---- Display
---- Linear Color
---- Load Default
---- DiS
---- MT
---- Power
---- Reset Cal.
---- Sensor Monitor
---- System Errors
---- Set
---- Manual
---- system
---- Chinese and English switch
---- Screen rotation
Main interface
5.4 Menu structure
User Manual •Instrukcja Obsługi
---- Dimmer
---- Strobe
---- Color
---- Gobo
---- Gobo Rotation
---- Focus
---- Zoom
---- Reset
5.5 Manual control
enter the host state (do not receive DMX signal, send DMX signal to the bus to the slave).
setup menu.
Options Explain
1CH. Dimming 0-255 Press the ‚OK’ key to enter the edit state. At this time,
select the hundreds place and press the „Up” and
„Down” keys to change the channel value. Press the
„OK” button again to select the ten digits for editing.
Press again to exit edit state
.... 0-255
7CH. Focusing 0-255
8CH. Reset 0-255
5.6 Set up
Options Explain
Operating
mode
DMX Slave status: Receive DMX signal from
console or host
Auto 1 Master status: self-propelled and send DMX
signal to slave
Auto 2
Random
Program
Scene Run Auto, Colse,
Scene 20, Scene
19... 1
Scene Set Scene Save, Scene Select (1-20) Scene Time, AutoRun (On/Off),
Dimmer, Shutter, Color, Gobo, Roto Gobo RT, Focus, Zoom
DMX Address 1-512
Channel Mode 8 CH
DMX Signall Keep/Clear
Display On/Off
Linear Color On/Off
Load Default On/Cancel
BIG LOGO PROJECTOR IP65 300W • Art No F7300250
BIT EFFECT REMARKS
255 100%
..... .....
0 O%
Channel Explain
8
1 DIMMER
2 STOP/STROBE
3 COLOUR WHEEL
4 EFFECT GOBO CHANGE
5 EFFECT GOBO ROTATION
6 ZOOM
7 FOCUS
8 RESET
5.8 Channel table
DIMMER - CHANNEL 1
User Manual •Instrukcja Obsługi
BIT EFFECT REMARKS
0-254 Strobe from Slow to Fast
255 OPEN (Dimmer)
STOP/STROBE - CHANNEL 2
BIG LOGO PROJECTOR IP65 300W • Art No F7300250
COLOUR WHEEL -CHANNEL 3
CH COLOUR REMARKS
0 White
8 Red/White
16 Red
24 Green/Red
32 Green
40 Blue/Green
48 Blue
56 Yellow/Blue
64 Yellow
72 Magenta/Yellow
80 Magenta
88 Cyan/Magenta
96 Cyan
104 Pink/Cyan
112 Pink
120 Orange/Pink
128 Orange
136 White/Orange
150-204 Colour Rotation from Fast to Slow
205-255 Colour Rotation from Slow to Fast
BIT EFFECT REMARKS
255 FAST ROTATION
..... .....
205 SlOW ROTATION
..... .....
150 FAST ROTATION
149 GOBO 9 SHAKE, FAST SPEED
..... .....
140 GOBO 9 SHAKE, SLOW SPEED
139 GOBO 8 SHAKE, FAST SPEED
..... .....
130 GOBO 8 SHAKE, SLOW SPEED
..... .....
99 GOBO 1 SHAKE, FAST SPEED
..... .....
90 GOBO 1 SHAKE, SLOW SPEED
89 WHITE SHAKE, FAST SPEED
..... .....
80 WHITE SHAKE, SLOW SPEED
70 GOBO 7
60 GOBO 6
50 GOBO 5
40 GOBO 4
30 GOBO 3
20 GOBO 2
10 GOBO 1
0 WHITE
EFFECT GOBO 1 CHANGE 4
User Manual •Instrukcja Obsługi
BIG LOGO PROJECTOR IP65 300W • Art No F7300250
BIT EFFECT REMARKS
255 FAST ROTATION
..... .....
195 SLOW ROTATION
..... .....
128 FAST ROTATION
0-127 POSITION
BIT EFFECT REMARKS
255 100%
..... .....
0 0%
BIT EFFECT REMARKS
255 100%
..... .....
0 0%
BIT EFFECT REMARKS
255 Reset
EFFECT GOBO 1 ROTATION 5
ZOOM - CHANNEL 6
FOCUS - CHANNEL 7
Reset - CHANNEL 8
OSTRZEŻENIE!
WAŻNE!
Rysunek 2.
User Manual •Instrukcja Obsługi
2. ZASADY BEZPIECZENSTWA
3. INFORMACJE O PRODUKCIE
4. INSTALACJA
BIG LOGO PROJECTOR IP65 300W. Ze
przez wykwalifikowany personel, aby
w dobrze wentylowanym pomieszczeniu,
uszkodzenia spowodowane niestabilnym
1. WPROWADZENIE
: 1 szt. 300W LED
Sterowanie: DMX 512
BIG LOGO PROJECTOR IP65 300W • Art No F7300250
DMX
Controller DMX 512 DMX 512
5.2 Specyfikacja zasilania
5.3 Podłączenie zasilania
Napięcie Zasilania Pobór Mocy Częstotliwość zasilania
110-240V 300W 50/60Hz
5.1 Podłączenie sygnału DMX
5. POLACZENIA
1
3
22
ŻEŃSKI
XLR
GROUND
DMX +
DMX -
MĘSKI
XLR
3
1
UWAGA!
wykwalifikowany personel techniczny.
ŻEŃSKI
XLR
1
GROUND
DMX +
DMX -
MALE
XLR
2
3
4
5
1
2
3
45
User Manual •Instrukcja Obsługi
BIG LOGO PROJECTOR IP65 300W • Art No F7300250
5.4 Struktura Menu
5.5 Obsługa
---- Run Mode
---- Scene Run
---- Scene Set
---- DMX Address
---- Channel Mode
---- DMX signal
---- Display
---- Linear Color
---- Load Default
---- DiS
---- MT
---- Power
---- Reset Cal.
---- Sensor Monitor
---- System Errors
---- Set
---- Manual
---- system
---- Chinese and English switch
---- Screen rotation
Main interface
---- Dimmer
---- Strobe
---- Color
---- Gobo
---- Gobo Rotation
---- Focus
---- Zoom
---- Reset
Options Explain
1CH. Dimming 0-255 Naciśnij przycisk „OK”, aby wejść w stan edycji. W tym
momencie należy wybrać klawiszami „Góra” i „Dół”
zmienić wartość kanału. Ponownie naciśnij przycisk
„OK”, . Naciśnij ponownie, aby wyjść ze stanu edycji.
.... 0-255
7CH. Focusing 0-255
8CH. Reset 0-255
User Manual •Instrukcja Obsługi
BIT EFFECT REMARKS
255 100%
..... .....
0 O%
Channel Explain
8
1 DIMMER
2 STOP/STROBE
3 COLOUR WHEEL
4 EFFECT GOBO CHANGE
5 EFFECT GOBO ROTATION
6 ZOOM
7 FOCUS
8 RESET
DIMMER - CHANNEL 1
BIT EFFECT REMARKS
0-254 Strobe from Slow to Fast
255 OPEN (Dimmer)
STOP/STROBE - CHANNEL 2
5.8 Channel table
Options Explain
Operating
mode
DMX Slave status: Receive DMX signal from
console or host
Auto 1 Master status: self-propelled and send DMX
signal to slave
Auto 2
Random
Program
Scene Run Auto, Colse,
Scene 20, Scene
19... 1
Scene Set Scene Save, Scene Select (1-20) Scene Time, AutoRun (On/Off),
Dimmer, Shutter, Color, Gobo, Roto Gobo RT, Focus, Zoom
DMX Address 1-512
Channel Mode 8 CH
DMX Signall Keep/Clear
Display On/Off
Linear Color On/Off
Load Default On/Cancel
BIG LOGO PROJECTOR IP65 300W • Art No F7300250
KOŁO KOLORÓW -CHANNEL 3
CH COLOUR REMARKS
0Biały
8Czerwony/Biały
16 Czerwony
24 Zielony/Czerwony
32 Zielony
40 Niebieski/Zielony
48 Niebieski
56 Żółty/Niebieski
64 Żółty
72 Magenta/Żółty
80 Magenta
88 Cyan/Magenta
96 Cyan
104 Różowy/Cyan
112 Różowy
120 Pomarańczowy/Różowy
128 Pomarańczowy
136 Biały/Pomarańczowy
150-204 Rotacja Koloru z Szybkiego do Wolnego
205-255 Rotacja Koloru z Wolnego do Szybkiego
User Manual •Instrukcja Obsługi
BIT EFFECT REMARKS
255 FAST ROTATION
..... .....
205 SlOW ROTATION
..... .....
150 FAST ROTATION
149 GOBO 9 SHAKE, FAST SPEED
..... .....
140 GOBO 9 SHAKE, SLOW SPEED
139 GOBO 8 SHAKE, FAST SPEED
..... .....
130 GOBO 8 SHAKE, SLOW SPEED
..... .....
99 GOBO 1 SHAKE, FAST SPEED
..... .....
90 GOBO 1 SHAKE, SLOW SPEED
89 WHITE SHAKE, FAST SPEED
..... .....
80 WHITE SHAKE, SLOW SPEED
70 GOBO 7
60 GOBO 6
50 GOBO 5
40 GOBO 4
30 GOBO 3
20 GOBO 2
10 GOBO 1
0 WHITE
EFFECT GOBO 1 CHANGE 4
BIG LOGO PROJECTOR IP65 300W • Art No F7300250
BIT EFFECT REMARKS
255 FAST ROTATION
..... .....
195 SLOW ROTATION
..... .....
128 FAST ROTATION
0-127 POSITION
BIT EFFECT REMARKS
255 100%
..... .....
0 0%
EFFECT GOBO 1 ROTATION 5
ZOOM - CHANNEL 6
BIT EFFECT REMARKS
255 100%
..... .....
0 0%
BIT EFFECT REMARKS
255 Reset
FOCUS - CHANNEL 7
Reset - CHANNEL 8
User Manual •Instrukcja Obsługi
BIG LOGO PROJECTOR IP65 300W • Art No F7300250
www.flash-butrym.pl
F7300250
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
w innych językach
- English: FLASH F7300250 User manual
Powiązane dokumenty
Inne dokumenty
-
Cameo Auro Spot 200 Instrukcja obsługi
-
Cameo OPUS® SP5+ Instrukcja obsługi
-
-
-
Beamz Pro IGNITE180B Instrukcja obsługi
-
-
Beamz Fuze75S Spot 75W LED Moving Head Instrukcja obsługi
-
-