Gronomics EGBD 24-48 Instrukcja obsługi

Marka
Gronomics
Model
EGBD 24-48
Typ
Instrukcja obsługi

Niniejsza instrukcja jest również odpowiednia dla

www.gronomics.com East Bethel, MN USA 763-753-7374
Continued
Parts List
ITEM QTY. PART # DESCRIPTION
1 4 3201 Corner Post, 4” x 4” x 32”
2 2 4502T Side Rail w/Cleat, 45” x 5-1/2” x 1”
3 4 2100T Side Rail, 21” x 5-1/2” x 1”
4 2 4501T Side Rail Narrow Center, 45” x 5-1/2” x 1
5 2 2101T Side Rail Narrow Center, “21” x 2-1/2” x 1”
6 2 4500T, L4500T Side Rail (one w/Logo), 45” x 5-1/2” x 1”
7 2 1201 Corner Notched Bottom Board, 22” x 4-1/2” x 1”
8 6 1200 Bottom Board, 22” x 4-1/2” x 1”
9 1 3100 Post Cap, 4” x 4” x 1-1/2”
10 4 F3652 Fabric Liner, 36” x 52”
1
Parts Identifi cation
Stack matching pieces in piles. Using the parts list, locate
and count the individual pieces and verify that you have
received the correct number of pieces.
If any pieces are missing or replacement parts are
required, contact Gronomics at 1-855-299-6727.
NOTE: It is recommended to place a protective layer
between the ground and the pieces during assembly. This
will help prevent damage to the pieces.
Elevated Garden Bed (24” x 48”)
Assembly Instruction
EGBD 24-48
EGBD 24-48S
5
6
8
9
3
4
7
1
10
10
Packaged & Inspected by: Date:
2
Side Rail Assembly
2
Stand two 4” x 4” x 32” corner posts (Item 1) upright with slots facing you
and slots facing each corner post.
Locate a 45” x 5 1/2 “ side rail w/cleat (Item 2). With the cleat located at the
bottom and facing you, install side rail w/cleat into the slots and slide down
to the bottom of the slots.
Repeat procedure for the two remaining corner posts and 45” x 5-1/2 “ side
rail w/cleat.
Cleat
1 1
2
www.gronomics.com East Bethel, MN USA 763-753-7374
Install two 21” x 5-1/2” side rails (Item 3) (with the groove down) into the
slots and slide down to the bottom of the slots.
5
Bottom Board and Fabric Installation
Place one 22” x 4-1/2” corner notched bottom board (Item 7) on each
end of the garden bed.
Place six 22” x 4-1/2” bottom boards (Item 8) into the garden bed. (Gap
boards evenly to allow for water drainage).
Place fabric liner into the garden bed.
Soil Capacity: 5.9 Cubic Feet.
3
End Rail Assembly
3
3
7
8
4
Final Side Rail Assembly
Install two 45” x 5-1/2” side rails (Item 6) (one w/Logo) into the slots on
each side of the garden bed and slide down.
Install two 21” x 5-1/2” side rails (Item 3) into the slots on each end of
the garden bed and slide down.
NOTE: Make sure the boards tongue and grooves fully seat together.
Logo
6
3
3
4
Narrow Center Side Rail Assembly
Install two 45” x 2-1/2” side rails (Item 4) into the slots on each side of
the garden bed and slide down.
Install two 21” x 2-1/2” side rails (Item 5) into the slots on each end of
the garden bed and slide down.
NOTE: Make sure the boards tongue and grooves fully seat together.
4
5
5
6
Post Cap Assembly
Remove the rubber cap from the corner posts studs.
Align the hole of the 4” x 4” post cap (Item 9) with stud and tighten until
the cap makes contact with the post.
NOTE: Do not overtighten.
Repeat procedure on all posts.
Rubber Cap
Stud
9
  • Page 1 1
  • Page 2 2

Gronomics EGBD 24-48 Instrukcja obsługi

Marka
Gronomics
Model
EGBD 24-48
Typ
Instrukcja obsługi
Niniejsza instrukcja jest również odpowiednia dla
Pobierz PDF
raport

w innych językach

Powiązane artykuły

Inne dokumenty