George Kovacs P1903-66A-L Instrukcja obsługi
- Typ
- Instrukcja obsługi
INSTALLATION INSTRUCTIONS
Item# P1903-66A-L (Rev. 11/10/2023)
READ AND SAVE THESE INSTRUCTIONS
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
\
PREPARATION
1.
Carefully remove the fixture from the carton and check that
all parts are included as shown in the illustration.
2.
Shut off power at the circuit breaker and remove the old
fixture including the mounting hardware.
MOUNTING THE FIXTURE (FIG. 1)
3.
To retract wire, gently push it into light fixture base. To
extend wire, push metal collar while gently pulling wire
down. When the metal collar is released, the wire will be
fixed into position. Now turn fixture over and slide plastic wire
retainer up to hex nut of canopy, as a secondary safety
precaution to prevent fixture from slipping down when in use.
4.
Loosen mounting plate screws (E) to remove mounting
plate (B) from canopy (D).
5.
Attach mounting plate (B) to outlet box (Not included) using
outlet box screws (C) (Size: #8-32N*L1''L) as shown in Fig.1.
Make sure side of mounting plate marked ''GND'' must face
out.
CONNECTING THE WIRES (FIG. 2)
6.
Connect the electrical wires as shown in Fig. 2, making sure
that all wire connectors are secured. If your outlet has a
ground wire (green or bare copper), connect fixture's
ground wire to it. Otherwise, connect fixture's ground wire
directly to mounting plate (B) using green screw provided.
7.
After wires are connected, carefully tuck them inside outlet
box.
FINISHING THE INSTALLATION (Fig.1)
8.
Mount canopy (D) onto mounting plate (B) and secure it
with mounting plate screws (E).
Your installation is now complete. Return power to the outlet
box and test the fixture.
Note: Illustration (Fig. 1) on this manual is for
installation purpose only. It may or may not be identical
to the fixture purchased.
Dimmable with ELV and/or LED compatible wall dimmer
switch.
Fig.1
Set #A-010-113
- Mounting Plate
-Ground Screw
-Outlet Box Screw *2
-Mounting Plate Screw *2
Fig.2
FIXTURE
WIRE S
Black or
Smooth
HOUSE
WIRES
White
( Neutral)
FIXTURE
WIRE S
Bare
Copper
(
Ground
)
FIXTURE
WIRE S
White or
Ribbed
HOUSE
WIRE S
Black
( Hot)
HOUSE
WIRE S
Green or Bsre
Copper
(Ground)
Page: 1/1
P1903-66A-L
IMPORTANT: FIXTURE SHOULD BE INSTALLED BY
A QUALIFIED ELECTRICIAN TO ENSURE PROPER
WIRING AND INSTALLATION.
-
1
