AlienPro MU-100 Instrukcja obsługi

Kategoria
Mikrofony
Typ
Instrukcja obsługi
alienpro.com.mx
MU-100
OPERATING MANUAL
8 1
www.alienpro.com.mx www.alienpro.com.mx
Pr oblem
Possible cause
Solution
No sound;
No lights
Reciver
No sound;
Lights on
Microphone
Power button is on the OFF
position
DC power adater is not plug in
Poor connection of DC power
adapter
Turn on the power button
Plug in the DC power adapter
Check to see if the DC power
adapter is loose. Check on the
receiver end and wall outlet end
Operate the machine in the
effective range
Turn on the microphone switch
Turn on the microphone volume
Reinstall the batteries. Make sur
e
the positive and negative end are
install correctly
Connect the to cable from t
he
receiver to a microphone input
(mixer, player, etc.)
1
4
1
4
Distorted sound;
feedback
Separate the microphone furt
her
away
Replace the batteries
Reduce the volume of the
microphone
Move the receiver away from
electric equipment
The transmitter is out of range
Microphone switch is off
Microphone volume is turn down
Batteries in the microphone
are not install properly
Receiver is not connect to an
amplifier, mixer or karaoke
player
The two microphones are too
close together
Batteries running low in
microphone
Microphone volume is too high
Distortion from other electric
wave
Parts checklist
Receiver
Antenna
Handheld microphone
Male to male 1/4 cable
DC power adapter
Normal AA battery
User manual
Quantity
1
1/2
1/2
1
1
2/4
1
Desktop receiver and enhanced muting, high signal/
noise ratio
Desktop receiver supports both balance & unbalance
Audio output.
Almost zero noise output when on standby.
Broad frequency response range super low distortion.
NO impact on switching receiver, ensure safety of rear
stage amplifier system and speaker.
Perfect operative status signals, LED indicater with
digital microphone.
Long practical distance. Over 100 m in ideal circumstance,
60 m radius in complex circumstances.
Modern audio compandor return your tone quality
extremely.
Troubleshooting
Packing Included
Features
2 7
www.alienpro.com.mx www.alienpro.com.mx
Before installing your wireless microphone, there are a few things you should
do and know:
Make sure your local power outlet supplies the correct voltage for the DC
adapter.Only use the adapters supplied with the system.
Turn offyour audio system during set-up and turn down volume.
Fully charge your batteries before using the system.
Plug the power adapter cord jack into the matching power socket on the
rear of the receiver. Make sure the power switch is OFF "0" and all volume
controls are turned down to the negative position before beginning any
installation
Do not dismantle the receiver on your own.For needed repairs, contact
your dealer
Make sure the power is disconnected before cleaning the receiver unit. Use a
soft cloth to clean the receiver and microphones. DO NOT use chemicals or
any cleaning agents to clean the receiver or microphones.
If you will not be using the system for an extended period of time,
disconnect all power sources. Remove the batteries from microphones.
First Things First
Care and Cleaning
Parameter/Receiver
Frequency Response
Transmitter
30mW
<40dB(with carrier)
LED
1.5v 2
Transmitter Power
Spurious Emission
Display
Battery Voltage
Battery Life
10 hours
Dimensions (m/m)
Carrier Wave Frequency Range
Oscillation Mode
Carrier Wave Stability
Sensitivity
S/N Ratio
T.H.D.
Image Rejection
Spurious Rejection
Frequency Responses
Working Distance
Squelch Control
AF Output Impedance
Max. Output Level
Display
Power Supply
Output Connector
206(L) 41(H) 130(D)
UHF 614~698MHz 740~900MHz
Quartz Controlled Fixed Frequency
10PPM
-105dB @ sinad=12 dB
>105dB
<0.5% @ 1KHz
85 dB typical
75 dB typical
40Hz~18KHz
200 feet
dual-squelch circuit
2.2KÙ
Balance : 0-400mv, Unbalance : 0-200mv
LED
External DC Power Supply, 0.35A, 12~18V DC
XLR Balanced Socket
Unbalance TRs 6.35mm Socket
6 3
www.alienpro.com.mx www.alienpro.com.mx
1
3
Power
Mic 1 Mic 2 Mic 3
Mic 1 Mic 2 Mic 3 Mic T reble
Mic Bass
Mic Echo
Music Volume
10 10 10 10
10
+10
-10
+10
-10
3D Sound
On O
KM-110
Karaoke M ixer
On O
Mic Volume
Power amplifier
M ixer
Player
Mic. Input
Mic. Input
Mic. Input
POWER
OFFON
1 2
3
4
5
6 7 8 9 0
MIC1 MIC2 VOL1 VOL2 ECHO BASS TREBL E
DOLBY
DIG ITA L
CD+G
MPEG-4
Playback
DVD MPE G-4 KAR AOK E PL AYER
DGX -106
SD/MMC
MINI SD
USB
2
Connect the DC POWERA DAPTER to the receivers DC INPUT 11 0V/220V,
then plug the other end of DC POWER ADAPTER into the WALL OUTLET
.
Connect one end of a " TO " CABLE to the receiver s UNBALANCE
AUDIO OUTPUT (MIX) and the other end to a karaoke mixer, karaoke
player or karaoke power amplifier " microphone input. If you are using
the BAL ANCE A UDIO OU TPUT, u se a XLR to XLR cable or XLR to"cable.
Install the antenna into each antenna socket on rear panel, then fasten the
antenna towards the right side till the antenna is vertical with ground.
Push/Open the microphones handle/bodypack cover to check to see
if there are batteries. If not, install the batteries into the microphones
with the negative and positive end of the battery correspond the negative
and positive end
of the microphone. Push/Close the microphone
handle/bodypack back on.
1
4
,
1
2
3
4
Receiver Receiver
Installation
Rear Panel
Front Panel
2
3
1
4
1
Unbalance audio output
2
Balance audio output
3
DC power jack
4
Antenna
1
2
3
4
Power switch
Volume control
RF-A
AF-A
2
1
3 4
4 5
www.alienpro.com.mx www.alienpro.com.mx
Receiver Transmitter
Rear Panel
2
1
Balance audio output A
Unbalance audio output
1
2
3
Volume control B
4
5
Front Panel
2
1
7
3
1
3
4
2
4 5 6
AF-B
Power switch
Volume control A
RF-A
AF-A
RF-B
6
7
56
3
Balance audio output B.
4
DC power jack.
5
Antenna A
6
Antenna B
Optional Transmitter
1
Cartridge module
2
Operating indicator
3
Power switch
4
Battery cover
Note : when the operating indicator lights up red, it means that the
battery is low, when it light up green, it means that the battery is
good, when there is no light, it means the microphone is off.
1) Install batteries.
2)Turn on microphone by pushing the switch towards the ON position.
3)After you are done singing, push the switch to the OFF position.
4)If you are not going to use the microphone for a long period of time,
turn off the microphone and pull out the batteries to avoid deterioration
and damage toward the components.
Operation:
5
Transmission antenna
6
Clip
5
3
4
6
1
2
Lavalier wireless MIC
1
2
3
4
5
Handheld wireless MIC
1
2
3
4
5
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5

AlienPro MU-100 Instrukcja obsługi

Kategoria
Mikrofony
Typ
Instrukcja obsługi

w innych językach