3 3/8” Disposer Trim

w/Basket Strainer, DR340

To use with I.S.E., Kitchen Aid, Emerson and Kenmore disposers only.

1. Separate the top mounting ring from the lower mounting ring.

2. Loosen the three bolt mounting assembly until even with top of the mounting ring.

3. Use a regular screw driver to pry off the snap ring.

4. Apply 100% Silicone

(non-water based) under the rim of your new disposer flange.

pops into place in the groove on the sleeve.

7. Hold the fiber gasket and metal back up ring in place with one hand and place the

mounting ring with the three bolt assembly onto the flange sleeve. Then push the

fiber gasket, metal back up ring and the mounting ring further up on the flange

sleeve and slide the snap ring onto the flange sleeve until it pops into place in the

groove on the sleeve.

8. Tighten the bolts on the three bolt mounting system until the whole mounting

system is seated evenly and tightly against the sink.

For replacing an existing waste disposer flange with a new Deluxe Flange and Stopper

1. First make sure power is turned off to the waste disposer unit before removing the disposer

Remove all excess silicone around the drain after the drain has been installed

INSTALLATION INSTRUCTIONS

Once the above is completed follow the next installation steps from your new Waste Disposer installation and

care manual which should be found in the box.