INSTALLATION INSTRUCTIONS
WARNINGS
Please read the following information before installing and using your heated towel rack
CAUTION
OPERATING INSTRUCTION
TOOLS REQUIRED
SKUS
INTEGRATED SWITCH
CONTACT
WARRANTY
• These units should be installed by a certified electrician in accordance with the National Electrical Code (NEC)and the Canadian Electrical Code (CEC).
• The unit requires a 120 volt, 60 Hz power source and should be installed on a GFCI protected circuit.
• Plug-in units should be connected to a grounded outlet with a minimum rating of 10 amps.
• Follow instructions to ensure he learned is securely fix the wall. Unit is designed for drying towels. Under no circumstances should anyone climb on or hang on unit.
• Unit is intended for indoor use only. Do not place units inside a shower, sauna, steam room, or wherever unit would be exposed to water.
• As this is a heating device, the surface temperature can increase depending on the ambient temperature in the room and the number of tiles apply to the unit.
• Overloading the unit can cause the unit to become extremely hot and they result in a burn it touched and or damage the towels.
• The fasteners provided with installation kit are for convenience only are not suitable for all installation conditions.
• It is the ultimate responsibility of the installer to ensure proper mounting hardware is employed in attaching the unit to the wall.
• After installation, connect electrical power.
• Remove the protective cover from the switch and turn it to the on position.
• The indicator light will glow red and the towel warmer will start to heat — allow 10–20 minutes to heat up.
• This towel warmer has been designed to run continuously-turn off the switch or unplug the cord in the tower is not in use for long periods of time.
• Never use an extension cord for plug-in models.
Two year limited warranty
with proof of purchase
will apply if all terms and
conditions of sale are met
and installation instructions
are adhered to.
INCLUDED COMPONENTS
• The radiant collection features an
integrated on/off switch.
• Remove plastic cover after installation
• Switch is located on the bottom of the left
vertical bar.
• Press switch to power on unit.
• Switch will illuminate when on.
P - POLISHED | B - BRUSHED
TEL: 404-350-9738
PAGE - 1
! CAUTION —SURFACE OF UNIT IS HOT WHEN ON !
EMAIL:
customerservice@ambaproducts.com
www.ambaproducts.com
FAX: 404-355-0166
2 YEARS
THE WARRANTY COVERS
DEFECTS IN WORKMANSHIP
AND MATERIALS
FOR FULL WARRANTY AND
TERMS OF SALE VISIT:
www.ambaproducts.com/warranty
PARAMETER
CONFORMS TO UL STD.499
CERTIFIED TO CSA STD C22.2 NO.64
TOWEL WARMER | MODEL: RWHL-S
RATED VOLTAGE: 120V~
RATED FREQUENCY: 60Hz
RATED POWER INPUT: 150W
SERIAL NO:
HOUSEHOLD USE ONLY
DO NOT IMMERSE IN WATER
HOT SURFACE: AVOID CONTACT
UTILISATION DU MÉNAGE SEULEMENT
NE PAS PLONGER DANS L’EAU
SURFACE CHAUDE ÉVITER CONTACT
CAUTION:
RWHL-SP | RWHL-SB
RADIANT LARGE STRAIGHT HARDWIRED