5
OPERATING YOUR NEW APPLIANCE
Before rst use, remove and safely discard any
packing material, promotional labels and tape
from the wae maker.
1. Wipe the wae maker cooking plates with
a damp sponge or cloth. Dry thoroughly and
close the lid.
2. Place the wae maker on a at, dry surface.
Ensure there is a minimum distance of 20cm
of space on all sides of the wae maker.
Do not place anything on top of the
wae maker.
3. Unwind the power cord completely and insert
the power plug into a grounded 220–240V
power outlet.
4. Turn the POWER / DARKNESS Control Dial
clockwise to the desired setting to start
pre-heating the wae maker. The POWER
light will be illuminated.
5. Use the POWER / DARKNESS control dial to
adjust the brownness of your wae. There are
7 darkness settings ranging from 1 (lightest)
to MAX (darkest). Rotate the dial clockwise
to increase the brownness or counterclockwise
to decrease it.
6. Once the wae maker has completed
preheating, three audible alerts will sound
and the READY light will illuminate.
7. Open the lid and pour approximately 125ml
of batter evenly on the center of the wae
plate. The batter should cover the peaks of
the wae plate.
NOTE
When using the wae maker for the rst
time you may notice a ne smoke haze.
This is caused by the initial heating
of some of the components and is not
a cause for concern.
8. Close the lid but keep the locking latch open.
As the cooking cycle progresses the READY
light will switch o.
9. At the end of the cooking cycle, three audible
alerts will sound and the READY light will
illuminate. Open the lid and carefully remove
your waes.
NOTE
There can be slight variations between
cooking cycles. If your waes are not at
your desired darkness, close the lid and
cook for an additional minute.
10. For the most consistent results, add the next
batch of batter immediately after removing the
cooked wae and repeat steps 7 through 8.
NOTE
If the next batch of batter is not added
immediately after removing the cooked
wae, close the lid and allow the wae
maker to properly reheat (the READY light
will switch o and then back on) before
adding batter.
11. If you are not cooking any more waes,
turn the POWER / DARKNESS control dial
to the OFF position.