The power cord plug has to be connected only to electric installation socket complying
applicable standards. Use of separate electric circuit with 16 A fuse is recommended.
– The electric socket must be easily accessible to easy disconnect the appliance
in dangerous and/or emergency situations.
– Do not insert to or take out the plug from a socket with wet hands and
do not pull the power cord!
– The appliance is intended for use in households only and for similar use (in shops,
offices and similar areas, in hotels, motels and other residential areas, in bed and
breakfast facilities)! It is not designed for commercial use!
– Do not use the appliance outdoor!
– Do not use the appliance as room heating device!
– Do not put any objects to the appliance.
– Unwind the power cord completely before you plug it in the electric socket.
– Do not use the appliance when you are barefoot or when your feet are wet.
– Do not leave the appliance unattended until it has completely cooled down!
– The ironing plate, the steam inlet hose and the resting surface for the iron located on the boiler
may become extremely hot which represents a risk of a burn injury. If you need to move
the appliance to a different place, do not touch the stand, the hose or the ironing surface!
– The connecting hose for the supply of steam between the iron and the boiler may
become very hot. Therefore, be extra cautious when manipulating the hose.
– Remove the scale from the boiler regularly according to the instructions in the
“Maintenance” chapter.
– ATTENTION: Do not use this heater in series with an external timer, remote controller
or any other device that switches on the appliance automatically, since a fire risk exists
when the heater is accidentally covered or displaced at the moment it switches on.
– Never iron or steam iron the clothes on persons (directly on body) and do not direct
the steam to any persons or animals.
– Never immerse the iron or the steam tank into water (even its parts)!
Do not wash it under running water!
– Make sure the supply cord does not get in touch with the hot surface of the iron!
– Let the appliance cool off before storing!
– Do not place the iron in such a way that could represent harm (e.g. fire, burn and scalding).
– Iron is not intended for use in places with explosive danger
– Due to production tests, the internal container can be misted up. Do not consider
it to be a defect when purchasing the iron.
– Do not lift or carry the appliance on the handle of the locked iron.
– Only fill the water tank with clear water (if water in your home is too hard, you can mix it 1:1
with
distilled water, or use demineralised water). Do not use any chemical agents and other
liquids, such as rust removers, aromatic substances, alcohol, various detergents, etc.
Do not add perfume, water from tumble dryer, vinegar, magnetically treated water (e.g.,
Aqua+), starch, descaling agents, ironing aids, chemically descaled water or other
chemicals as they may cause water spitting, brown staining or damage to your appliance.
– Make sure that the power cord and steam hose is always dry and it is not damaged.
– Regularly check condition of the appliance power cord and steam hose.
– The power cord and steam hose must not be damaged with sharp or hot objects, open
fire, it must not be sunk into water or bent over sharp edges. Never put it to hot surfaces,
prevent its free hanging over edge of table or work board. Touching, stumbling or pulling
the power cord e.g. by children may cause tipping over or falling of the appliance with
subsequent severe injury!
– If you need to use the extension cord, it has to be uncorrupted and it has to comply with
the valid standards.
20
EN
/ 50