CleanSpa Hand Held Bidet - Installation Instructions
Parts Included:
• Bidet Sprayer Head
• T-valve w/Shut Off
• Flat Rubber Washer
• Spiral Metal Bidet Hose
• Sprayer Holster & Screws for
Mounting (wall & toilet options)
Before Installation:
Check water supply line: If the line that connects the toilet tank to the water
shutoff valve is a rigid pipe, you will need to purchase a flexible hose to replace
it before installing the CleanSpa. The length of the hose and size of the
connectors will vary.
Operation:
Open the T-valve Shut Off Valve to allow water to flow to the Bidet Sprayer Head.
Direct the hand held Bidet Sprayer Head in the appropriate direction and
press the button to release the water wash. (Image 5)
To adjust the wash spray, gently turn the head of the Bidet Sprayer
counter-clockwise to go from a shower spray to a single stream.
To stop water wash, push Bidet Sprayer Head button into the “off” position
(button pushed out towards the spray head)
IMPORTANT!
Manufacturers Recommendation: After each use, TURN OFF the T-valve Shut Off Valve to close the water
supply to the Bidet Sprayer Head. Failure to turn off after each use may weaken the Bidet Hose/Sprayer Head
or cause flooding. Manufacturer is not responsible for damage which may be caused by failure to follow the
above recommendation.
Installation:
Turn off water supply valve for the toilet (at the wall) and flush toilet
(holding down handle) to completely empty the tank. (Image 1)
Disconnect flexible water supply line directly under the toilet tank. Put the
Flat Rubber Washer inside the top of the T-valve w/Shut Off. Connect
T-valve w/Shut Off at the toilet tank, and reconnect the flexible water
supply line to the bottom of the T-valve. Be sure not to over tighten
connections. (Image 2)
Attach one end of Spiral Metal Bidet Hose to open end of T-valve w/Shut Off
and the other end to the Bidet Sprayer Head. (Image 3)
Mount Sprayer Holster: (Note: when mounting Bidet Sprayer Head, make
sure the spray button is pushed out towards the spray head as pictured, this
is the “off” position)
a. Wall Mount - using only the Sprayer Holster piece, find appropriate
spot on wall near toilet and use screw (included) to attach Holster to wall.
b. Toilet Mount - attach Sprayer Holster piece to toilet mount piece using
small screw (included). Hang mount on side of toilet in desired location.
(Image 4)
Turn water supply valve back on at the wall and check for leaks using
plumbers tape when necessary. Wait 5 minutes and check again. If no leaks,
then you are done!
1
2
3
4
5
1)
1)
2)
2)
3)
4)
3)
4)
5)
-
1
