ROOMS TO GO 90600682 Assembly Instructions

ROOMS TO GO
Marka
ROOMS TO GO
Model
90600682
Typ
Assembly Instructions
P.O. Box 558 | 3325 Grassy Hill Road | Rocky Mount, VA | 24151
www.uttermost.com
21536
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER WHILE POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
We suggest a licensed electrician for all fixture installations.
Installation Steps
1. Carefully unpack your new fixture and lay out all the
parts on a clear surface.
2. Adjust the cord to your desired length by loosen the
plastic screw on the connector. Adjusted to desired
length and screw on the plastic screw. Remove excess
wire.
3. Thread the Mounting screws into the matching holes of
the Mounting bar, and tighten with the Hex nut. Thread
the Ground screw into the hole of the Mounting bar.
Secure the Mounting bar to the outlet box with the
Outlet box screws.
4. Make Wire connections with Wire Connector:
---The smooth wire (w/ marking) from fixture to
Black Wire from power source.
---The ribbed wire (w/o marking) from Fixture to
White Wire from power source.
---Attach the Ground Wire and house ground
wire to the Mounting bar with the green Ground
screw.
Carefully tuck wires back into the Outlet Box.
5. Place the fixture Canopy over the two Mounting screws
so they protrude through the holes in the Canopy.
Thread the Ball nut onto the Mounting screws and
continue turning until the fixture is snug against the
ceiling.
6. Install the light bulb in accordance with the fixture’s specifications.
DO NOT EXCEED THE MAXIMUM WATTAGE RATING!
7. Turn on the power at fuse or Circuit Box.
WARNING:
Plastic screw
C A N O PY
O U TLET BO X
BA LL N U T
O U TLET BO X SCREW
H EX N U T
M O U N TIN G SCR EW
M O U N TIN G BA R
G RO U P W IRE
W IR E N U T
M O U N TIN G STA R P
G RO U P SCR EW SCR EW
SO CK ET
SH A D E
Connector
  • Page 1 1

ROOMS TO GO 90600682 Assembly Instructions

ROOMS TO GO
Marka
ROOMS TO GO
Model
90600682
Typ
Assembly Instructions
ściągnij PDF
raport

w innych językach

Inne dokumenty