Concrete (reinforced) wall Mounted installation:
Please note, when you use the electric drill, you should wear the eyes
protection goggles.
Step 1: Take the electric drill and use drill bit to drill a 35mm deep
hole. Then clean the hole.
Step 2: Take the plastic screw anchors, using hammer to insert the
anchors into the hole.
Step 3: Take the screws, use screw driver, and screw them through
the xing holder onto the plastic anchors.
Step 4: Fix the main unit on the xing holder.
Wall mounted installation with the Velcro tape:
Step 1: Find the xing position and make sure the antenna can get a
good signal reception. - The areas where the Velcro tape
should be placed, needs to be clean.
Step 2: Attach one side of the Velcro tape to the back of the antenna,
and another side of the Velcro tape to the position you want to
x the antenna.
Step 3: Fix the main unit to the position.
TROUBLE SHOOTING
1. If you can not get the digital programs as you expect, please check
the following conditions:
a. Check the connections. Make sure all connections are correct.
b. Check the antenna power function of your receiver. DA-6 is an
active antenna. You will need to enable the antenna power
function. (Please check the manual of the receiver or TV.)
c. If you place the DA-6 antenna on the TV panel, please try to
move the antenna away from the TV panel. Some panels can
reduce the signal reception.
2. Adjust the direction and position of antenna
to nd the best reception angle.
3
GB - English
USER MANUAL