128-7450
2 of 2
KEYLESS ENTRY
1. The Lock button on the transmitter is used to lock the vehicle's doors,
the Unlock button is used to unlock the vehicle's doors. To lock or
unlock the doors simply press and release the desired function button
one time. As a keyless entry unit, for your convenience, the parking
lights will flash once when the doors are locked and twice when the
door are unlocked.
REMOTE CAR FINDER
The Lock or Unlock buttons are also used to access the car finder mode.
This feature is particularly useful in a crowded parking lot where find-
ing your car may be difficult. To access the car finder mode, while
within range of your car, simply press and hold either the lock or unlock
button of your transmitter for three seconds. The parking lights will
begin to flash making your vehicle more visible. The lights will stop automatically
after 30 seconds. If you wish to turn off the car finder mode prior to the expiration of the
30 second timer, press and release either the lock or unlock button of your transmitter one
time
REMOTE TRUNK RELEASE
If you have electric trunk release in your vehicle and the remote trunk release option was
added to your vehicle, simply press and hold the Key/Trunk button of your keychain
transmitter for 4 seconds or until the electric trunk of your vehicle opens.
. .
REMOTE STARTING THE VEHICLE
This unit will not start the vehicle if any one of the following situations exists;
The vehicle's hood lid is opened.
The gear shift selector is not in Park.
The brake pedal is depressed.
The safety control switch is in the Off position.
1. To start the vehicle, press and release the Key/Option button two times within 2 seconds.
The vehicle will start and remain running for the pre-programmed 5,10,15,20 minute run
cycle. As a visual indication, the parking lights will flash or remain on depending on the
setting by your installation center.
2. When you arrive at the vehicle, turn the ignition key to the ON position (not the spring
loaded start position), then step on the brake pedal to disengage the remote starter. The
vehicle will continue to run, but now on it's own power.
NOTE: The engine will stop running before the pre-programmed run cycle has expired if
you perform any one of the following functions;
-Press and release button 2 on the keychain transmitter two times within 2 seconds.
-Depress the brake pedal.
-Open the vehicle's hood
-Move the safety control switch to the Off position.
SAFETY CONTROL SWITCH
The red handle control switch allows you to temporarily disable the remote starting function
of the system and moving this switch to the Off position is recommended whenever the
vehicle is being serviced. When the system is disabled, the remote door locks and optional
accessories will remain operational.
FUNCTION SETTING CHART
To be completed by installer
Run Time 5 Min o 10 Min o 15 Min o 20 Min o
Door Lock Timer 1 Sec/1 Sec o 3.5 o 1 Sec/Dbl 1 Sec o
Lights Pulse o Steady o
© 2005 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, NY 11788 128-7450