ITC Shoul Underwater Light Instrukcja instalacji

Shoul Underwater Light
ITC
Marka
ITC
Model
Shoul Underwater Light
Typ
Instrukcja instalacji
3030 Corporate Grove Dr.
Hudsonville, MI 49426
Phone: 616.396.1355
itc-us.com
Safety/Installation Considerations
• Disconnect power before installing, adding or changing any component.
• To avoid a hazard to children, account for all parts and destroy all packing materials.
• Lights are designed for underwater usage only.
• Electrical Specs:
Standard SHOUL - Input voltage: 10-24V DC| Max Wattage: 60W | Max Current: 5A @ 12V
Mini SHOUL - Input voltage: 10-24V DC| Max Wattage: 16W | Max Current: 1.12A @ 12V
• Positive (+) outputs require a fuse if the attached wire leads are not rated to handle the max current.
1. Determine the installation location and drill a 1/2” hole for the wiring. Wire to the boats power using the
wiring diagram below.
PARTS / TOOLS NEEDED:
Underwater Light
RGBW Controller or
3-Position Switch
(not provided)
Mounting Screws Power Drill Marine Grade Sealant
(not provided)
Marine Grade Splices
(not provided)
2. Install light using included screws. Make sure to seal around the outside perimeter of the light using a
marine grade sealant.
INSTALLATION INSTRUCTIONS
Shoul™ Underwater
Light
Part#: 6968X-KKKK
For warranty information please visit www.itc-us.com/warranty-return-policy
DOC #: 710-00185 • Rev D • 08/24/22
Page 1 of 2
3030 Corporate Grove Dr.
Hudsonville, MI 49426
Phone: 616.396.1355
itc-us.com
3. Wiring Diagram
Negative (-)
RGB(W)
Controller
Positive (+)
Incoming
10V - 24V
Power
Green (G) (-)
White/Red (+)*
Underwater
Light
Red (R) (-)
Blue (B) (-)
White (W) (-)
Negative (-)
Positive (+)
Negative (-)
3-Position
Switch
Incoming
10V - 24V
Power
Underwater
Light
Blue (B) (-)
White (W) (-)
Negative (-)
Positive (+)
RGBW Wiring
Blue/White Two Color Wiring
*Note, there will be an extra white/red wire on the RGB(W) controller that should be capped. On the underwater light, any unused
colors should be capped or connected to the V+ line. For example, if using a RGB controller, the white (W) wire from the underwa-
ter light should be capped or connected to the V+ line. Underwater Light Wire Gauges : Positive (+)/ Negative (-) - 18AWG RGBW
- 24AWG (Signal wires only <0.1A)
For warranty information please visit www.itc-us.com/warranty-return-policy
DOC #: 710-00185 • Rev D • 08/24/22
Page 2 of 2
  • Page 1 1
  • Page 2 2

ITC Shoul Underwater Light Instrukcja instalacji

Shoul Underwater Light
ITC
Marka
ITC
Model
Shoul Underwater Light
Typ
Instrukcja instalacji
ściągnij PDF
raport

w innych językach

Inne dokumenty