F AB G L A S S
AND MIRROR
Fab Glass Noguchi Style Coffee Table
Installation Manual
www.fabglassandmirror.com Call: +1 888-474-2221 Fax: (614)-334-4919
Office Timing: 8:30 - 18:00 EST [email protected]
Thank you for your purchase! It is our desire to make your entire experience from
purchase to installation as easy as possible. We ask that you read each step of this
installation manual thoroughly to ensure proper installation of your new Noguchi Style
Glass Table. Our installation techniques are very important. Installing your table in any
manner other than the steps outlined in this manual may lead to structural failure of
your table.
It is your responsibility to see that your Glass Table is properly assembled, installed, and
cared for. Failure to follow instructions in this manual could result in serious injury. Use
this product with Glass cautions.
Hardware Included with this order
CAUTION
Rod
(Qty - 3)
Seprator
(Qty - 1)
Tighten Key
(Qty - 1)
Base (Legs)
(Qty - 2)
Plastic Cap
(Qty - 3)
Steel Cap
(Qty - 3)
1
2
3
4
By using your cutting tool,
carefully open the
package and remove
the table and hardware.
Set the Glass table top
side down on a flat
surface, and screw the
included rods into their
mounting sockets.
Slide one base leg over
the two rods of the table
as shown in illustration,
and place the separator
disk over the rod towards
the narrowest end of the
table.
Slide the second base leg
over the rods, with the
short end of the leg over
the rod with the separator
disk.
www.fabglassandmirror.com
+ 1 888-474-2221
Fragile Handle with care
F AB GLASS
A N D MIRRO R
Glass Table Top
Rod
Seprator
Base
Base
www.fabglassandmirror.com
+ 1 888-474-2221
Fragile Handle with care
FRAGILE
GLASS
F AB GLASS
AND M I R ROR
5
6
Place the steel end caps
over the tips of the rods
extending from the base
legs, then the three plastic
protective covers. Tighten
all three with the included
tool.
Congratulations!
You have successfully assembled your
Noguchi Style Coffee Table.
Tighten key
Plastic Cap
Steel Cap
-
1
-
2
-
3
-
4
