- 10 -
Carbon lter saturation indicator
If the symbol appears on the display, the carbon lter should be re-
placed.
To acknowledge the message, touch and hold for approximately 10
seconds.
Note: The symbol will also appear when kitchen hood operates in
extraction mode with no carbon lter. In this case, ignore the message
and turn it o.
Note: The symbol will be displayed after approximately 220 hours of
fan operation.
Aluminium lter cleaning indicator
If the symbol appears on the display, you need to clean the alumini-
um lters.
To acknowledge the message, touch and hold for approximately 10
seconds.
Note: The symbol will be displayed after approximately 110 hours of
fan operation.
Odour sensor*
When active, the odour intensity level is detected. When certain odour
intensity threshold is reached, the fan will start at the appropriate
speed.
• When odour intensity is reduced, the fan will slow down to a lower
speed until it eventually stops completely.
• When there no reduction in odour intensity, the fan will continue to
run.
• When odour intensity rises, fan speed will increase.
In high odour intensity, the fan will run at speed 4 and then speed will
be reduced by one speed level at 1 minute intervals until it stop com-
pletely.
Activate automatic odour detection and calibrate the sensor: In normal
conditions when no food is cooked in close proximity to the appliance,
connect your kitchen hood to the power supply. After 5 minutes, press
and hold for about 2 seconds. The symbol will be displayed, and
adjacent dot will ash for 1-2 minutes (depending on the conditions in
the room it may take longer). Flashing dot indicates sensor calibration.
When the dot stops ashing (and disappears), the sensor is properly
calibrated and now the hood is in automatic mode.
Press and hold for approximately 2 seconds to turn o the function.
Note: Each time you activate the automatic operation, the sensor will
be calibrated. When the hood is disconnected from the power supply
(power outage) and activate the automatic operation, the sensor will be
calibrated.
Child Lock
The cooker hood has a child lock safety device. This function is also
useful when cleaning the cooker hood control panel. Touch and hold
for 3 seconds to activate or deactivate the Child Lock function.
* Varies depending on the model