HP (Hewlett-Packard) Power Supply 5998-1958 Instrukcja obsługi

Kategoria
Zasilacze
Typ
Instrukcja obsługi

Ten podręcznik jest również odpowiedni dla

Hot Swappable Power Supply
Ordering Guide
for HP A5800-48G-PoE+ Switch with 2 Interface Slots
Part number: 5998-1958
Document version: 6W100-20110408
Legal and notice information
© Copyright 2011 Hewlett-Packard Development Company, L.P.
No part of this documentation may be reproduced or transmitted in any form or by any means without
prior written consent of Hewlett-Packard Development Company, L.P.
The information contained herein is subject to change without notice.
HEWLETT-PACKARD COMPANY MAKES NO WARRANTY OF ANY KIND WITH REGARD TO THIS
MATERIAL, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY
AND FITNESS FOR A PARTICULAR PURPOSE. Hewlett-Packard shall not be liable for errors contained
herein or for incidental or consequential damages in connection with the furnishing, performance, or
use of this material.
The only warranties for HP products and services are set forth in the express warranty statements
accompanying such products and services. Nothing herein should be construed as constituting an
additional warranty. HP shall not be liable for technical or editorial errors or omissions contained
herein.
Contacting HP
For worldwide technical support information, see the HP support website:
http://www.hp.com/support
Before contacting HP, collect the following information:
Product model names and numbers
Technical support registration number (if applicable)
Product serial numbers
Error messages
Operating system type and revision level
Detailed questions
Subscription service
HP recommends that you register your product at the Subscriber's Choice for Business website:
http://www.hp.com/go/e-updates
After registering, you will receive e-mail notification of product enhancements, new driver versions,
firmware updates, and other product resources.
Warranty
The Hewlett-Packard Limited Warranty Statement for this product and the HP Software License Terms
which apply to any software accompanying this product are available on the HP networking Web site
at
www.hp.com/networking/warranty. The customer warranty support and services information are
available on the HP networking Web site at
www.hp.com/networking/support. Additionally, your
HP-authorized network reseller can provide you with assistance, both with services that they offer and
with services offered by HP.
Documentation
For the latest documentation, visit the HP website, www.hp.com, and select the Support &
Troubleshooting link.
Choose See support and troubleshooting information radio button
Enter product name/number OR choose the automatic product name/number detection OR select
a product category
From the product page, choose Manuals link to see the documentation associated with your
product.
1
Hot Swappable Power Supply Ordering Guide
Power supply overview
Adopting advanced power supply design, the HP A5800-48G-PoE+ Switch with 2 Interface Slots
(hereafter referred to as A5800-48G-PoE+ (2 slot)) and HP A5800-48G-PoE+ TAA Switch with 2
Interface Slots (hereafter referred to as A5800-48G-PoE+ TAA (2 slot)) features the following:
Adopting hot swappable power supply design, each switch providing two hot swappable power
supply slots, as shown in
Figure 1.
Supporting different models of hot swappable power supplies. For more information, see
Table 1.
Supporting combination of different hot swappable power supplies. You can select them as
needed. For more information, see
Table 2.
Figure 1 Location of power supplies on an A5800-48G-PoE+ (2 slot)/A5800-48G-PoE+ TAA (2 slot)
(rear panel)
(1) Hot swappable power
supply 1
(2) Filler module (Remove the module when hot swappable power supply 1 is
a 750 W power supply.)
(3) Hot swappable power
supply 2
(4) Filler module (Remove the module when hot swappable power supply 2 is
a 750 W power supply.)
NOTE:
The A5800-48G-PoE+ (2 slot)/A5800-48G-PoE+ TAA (2 slot) provides two power supply slots on its
rear panel. Hot swappable power supply
slot 1 is empty when the switch is shipped, and hot swappable
power supply slot 2 is installed with a filler panel.
Figure 1 illustrates a switch with two PSR300-12A AC
power supplies.
Table 1 Power supply models supported by the A5800-48G-PoE+ (2 slot)/A5800-48G-PoE+ TAA (2
slot)
Model Power supply mode
PSR300-12A (JC087A) AC input (Rated voltage range: 100 VAC to 240 VAC; 50 Hz or 60 Hz)
2
Model Power supply mode
PSR300-12D1
(JC090A)
–48 VDC equipment-room power supply (Rated voltage range: –48 VDC to –60
VDC)
HP A-RPS1600 (JG136A) DC power supply (Rated voltage range: –52 VDC to –55
VDC)
PSR750-A (JC089A) AC input (Rated voltage range: 100 VAC to 240 VAC; 50 Hz or 60 Hz)
3
Guide to purchase
Table 2 Hot swappable power supply configuration of the A5800-48G-PoE+ (2
slot)/A5800-48G-PoE+ TAA (2 slot)
Model (Slot 1) Model (Slot 2) 30 W PoE 15.4 W PoE Remarks
PSR300-12A Not supported Not supported
PSR300-12D1 Not supported Not supported
PSR300-12A PSR300-12A Not supported Not supported Power supply backup
PSR300-12D1 PSR300-12D1 Not supported Not supported Power supply backup
PSR300-12A PSR300-12D1 Not supported Not supported Power supply backup
PSR750-A —
12-port middle
power PoE (30 W)
24-port standard PoE
(15.4 W)
Maximum PoE
power: 425 W
PSR750-A PSR750-A
24-port middle
power PoE (30 W)
48-port standard PoE
(15.4 W)
Maximum PoE
power: 740 W
CAUTION:
Do not plug a 300 W power supply (PSR300-12A or PSR300-12D1) and a 750 W power supply
(PSR750-A) on one A5800-48G-PoE+ (2 slot)/A5800-48G-PoE+ TAA (2 slot).
Purchase a power supply according to whether PoE is needed and the power of powered devices (PDs)
to ensure normal PoE power supply. For the introduction and installation of hot swappable power
supplies, see the corresponding power supply user manual or
HP A5800 Switch Series Installation
Guide
.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

HP (Hewlett-Packard) Power Supply 5998-1958 Instrukcja obsługi

Kategoria
Zasilacze
Typ
Instrukcja obsługi
Ten podręcznik jest również odpowiedni dla