5019 618 33016
HOO 050 - 051 - 054
HOO A00 - A10 - A40
PRODUCT SHEET
1. Control panel.
2. Self-supporting grease filters
(depending on model).
3. Extractor grille with internal grease filter
(depending on model).
4. Lighting unit.
Bulb maintenance
1. Disconnect the electrical power supply.
2. Open the extractor grille or remove the self-
supporting grease filter (depending on model).
Fig. 1 (a-b).
3. Remove the burnt-out bulb.
Replace using 40 W max E14 bulbs only.
4. Refit the extractor grille or grease filter.
Fitting or renewing the carbon filter:
1. Disconnect the electrical power supply.
2. Open the extractor grille or remove the self-
supporting grease filter (depending on model).
Fig. 1 (a-b).
3. To access the carbon filter seat, rotate the knobs
90° and open the lid. Fig. 2 (c).
4. Fit the shaped carbon filter in its default location.
Fig. 2 (d).
5. Turn the carbon filter locking knob 90° (check
that the filter is secured, otherwise rotate it
further). Fig. 2 (e).
6. Close the carbon filter compartment
7. Refit the extractor grille or grease filter.
To remove the carbon filter, proceed in reverse
order.
Grease filter maintenance:
1. Disconnect the electrical power supply.
2. Open the extractor grille or remove the self-
supporting grease filter (in this last case wash the
filter immediately). Fig. 1 (a-b).
3. Remove the device securing the grease filter.
Fig. 3 (e).
4. Remove the dirty grease filter.
5. After the grease filter has been replaced or
cleaned (depending on model), refit the parts in
reverse order, making sure the entire extraction
surface is covered.
CONTROL PANEL
Light switch.
The switch has two positions
(lights OFF - lights ON).
To switch on the lights: move the switch to the
right.
Extraction speed selection switch.
The extraction speed switch has different settings,
depending on the amount of steam and fumes.
To increase the extraction speed: move the
switch to the right.
Fig. 1
Fig. 2
e
Fig. 3
PL
SK
H
RUS
CZ
BG
RO GB
61833016.fm Page 12 Wednesday, November 17, 2004 12:18 PM