Havis-Shields C-VS-1200-EXPD-1 Instrukcja obsługi

Marka: Havis-Shields

Model: C-VS-1200-EXPD-1

Kategoria: Zestawy samochodowe

Typ: Instrukcja obsługi

INSTALL INSTRUCTIONS C-VS-1200-EXPD-1

VEHICLE SPECIFIC CONSOLE

2007-2008 FORD EXPEDITION (w/ Console shifter)

TOOLS REQUIRED:

Ratcheting wrench

Sockets Set

Panel pulling tool

Screwdriver set

T-20 torx bit

HARDWARE:

QTY

DESCRIPTION PART #

4 #10 x ½” Phillips machine screw GSM33118

4 #10 Keps nut GSM30028

Always!

 Read all instructions before installing any Havis-Shields Equipment Corp products.

 Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!

 Use hardware provided with install kit

 For product support, visit the Install Instructions Section of our website at

http://havis.com/Installation/Installation.html

Front

#10 x ½” Machine

screws and keps nuts

Rear

C-VS-1200-EXPD-1

C-VS-1200-EXPD-1_INST_9-07

View of vehicle w/ full console

& console shifter

Remove accessory pocket liner

as shown above

Remove trim panel from

console.

Remove hex head screw from

accessory pocket/armrest

View of panel removed

Remove hex head screw from

accessory pocket

CAREFULLY remove trim

from around gear shifter

Remove trim from around the

cup holders

C-VS-1200-EXPD-1_INST_9-07

Parts removed from OEM

console

Completely remove the container

of the accessory pocket

Remove hex head screws holding

lower sides accessory pocket

Remove hex head screws holding

side of accessory pocket

Remove hex head screws

holding rear of accessory pocket

Remove the rear OEM cup

holder

Pry up on accessory pocket trim

panel and remove

Remove (4) hex screws holding

armrest pad from hinge

C-VS-1200-EXPD-1_INST_9-07

Replace the trim panel around

gear shifter

Replace trim panel around

factory cup holder

Replace the trim panel

previously removed earlier

Install #10 x ½” machine

screws and keps nuts as shown

above

View of console installed

View of specific application

including C-TCB-24, C-

ARM-2, C-3090-7, control

heads, etc..(Sold Seperatly)

Replace hex head screw on

accessory pocket

Position console so holes in side

of console align w/ holes in

factory console

Replace rear cup holders

Havis-Shields C-VS-1200-EXPD-1 Instrukcja obsługi

Marka: Havis-Shields

Model: C-VS-1200-EXPD-1

Kategoria: Zestawy samochodowe

Typ: Instrukcja obsługi

ściągnij PDF

raport

w innych językach

English: Havis-Shields C-VS-1200-EXPD-1 User manual

Havis-Shields C-VS-1200-EXPD-1 Instrukcja obsługi

Havis-Shields C-VS-1200-EXPD-1 Instrukcja obsługi

w innych językach

Inne dokumenty