Audiovox 1285863 Instrukcja obsługi

Kategoria
Zdalne rozruszniki
Typ
Instrukcja obsługi
3 Channel Remote
Car Starter
Model AA-RS5CS
Owner’s Manual
FEATURES :
w 2 Two Button Programmable RF Transmitters
w Three Channel Receiver
(capable of accepting 4 transmitters)
w (+) & (-) Keyless Entry Outputs
w On-Board Start Relay
w On-Board Accessory Relay
w On-Board Ignition 1 Relay
w On-Board Ignition 2 Relay
w Ignition 2 Relay Selectable On or Off During Cranking
w On-Board Parking Light Relay
w Ignition 3 / Shock By-Pass / GM VAT Output (relay required)
w Tach Signal Learning Circuit
w Two ( + ) and Two ( - ) Safety Shutdown Circuits
w Alarm By-Pass Output
w Factory Disarm Output Before Start And During Unlock
w Selectable Steady or Flashing Parking Lights for Run Indication
w Selectable 5, 10, 15, 20 Minute Run Time
w Selectable 1 Second or 3.5 Second Door Lock Output Pulse
KEYLESS ENTRY
1. Button 1 on the transmitter is used to lock and unlock the vehicle's doors. To lock or unlock the doors
simply press and release this button one time. As a keyless entry unit, for your
convenience, the parking lights will flash once when the doors are locked and twice
when the door are unlocked.
REMOTE CAR FINDER
Button 1 is also used to access the car finder mode. This feature is particularly
useful in a crowded parking lot where finding your car may be difficult. To access the
car finder mode, while within range of your car, simply press and hold button 1 of
your transmitter for three seconds. The parking lights will begin to flash making your
vehicle more visible. The lights will stop automatically after 30 seconds. If you wish
to turn off the car finder mode prior to the expiration of the 30 second timer, press
and release button one of your transmitter one time
.
REMOTE STARTING THE VEHICLE
The AA-RS5 will not start the vehicle if any one of the following situations exists;
The vehicle's hood lid is opened.
The gear shift selector is not in Park.
The brake pedal is depressed.
The safety control switch is in the Off position.
1. To start the vehicle, press and release the second transmitter button two times within 2 seconds.
The vehicle will start and remain running for the pre-programmed 5,10, 15, 20 minute run cycle. As
a visual indication, the parking lights will flash or remain on depending on the setting by your
installation center.
2. When you arrive at the vehicle, turn the ignition key to the ON position (not the spring loaded start
position), then step on the brake pedal to disengage the remote starter. The vehicle will continue to
run, but now on it's own power.
NOTE: The engine will stop running before the pre-programmed run cycle has expired if you perform
any one of the following functions;
-Press and release button 2 on the keychain transmitter two times within 2 seconds.
-Depress the brake pedal.
-Open the vehicle's hood
-Move the safety control switch to the Off position.
SAFETY CONTROL SWITCH
The control switch allows you to temporarily disable the remote starting function of the system and
moving this switch to the Off position is recommended whenever the vehicle is being serviced. When
the system is disabled, the remote door locks and optional accessories will remain operational.
FUNCTION SETTING CHART
To be completed by installer
Door Lock Timer 1 Sec/1 Sec o 3.5 o 1 Sec/Dbl 1 Sec o
Lights Pulse o Steady o
Run Time 5 Min o 10 Min o 15 Min o 20 Min o
© 2000 Audiovox Electronic Corp., 150 Marcus Blvd., Hauppauge, N.Y. 11788 128-5863
  • Page 1 1
  • Page 2 2

Audiovox 1285863 Instrukcja obsługi

Kategoria
Zdalne rozruszniki
Typ
Instrukcja obsługi

w innych językach