KEYLESS ENTRY
1. Button 1 on the transmitter is used to lock and unlock the vehicle's doors. To lock or unlock
the doors simply press and release this button one time. As a keyless entry unit, for your
convenience, the parking lights will flash once when the doors are locked and twice when
the door are unlocked.
REMOTE CAR FINDER
Button 1 is also used to access the car finder mode. This feature is particularly
useful in a crowded parking lot where finding your car may be difficult. To
access the car finder mode, while within range of your car, simply press and
hold button 1 of your transmitter for three seconds. The parking lights will
begin to flash making your vehicle more visible. The lights will stop
automatically after 30 seconds. If you wish to turn off the car finder mode prior
to the expiration of the 30 second timer, press and release button one of your
transmitter one time
.
REMOTE STARTING THE VEHICLE
The APS-55 will not start the vehicle if any one of the following situations exists;
The vehicle's hood lid is opened.
The gear shift selector is not in Park.
The brake pedal is depressed.
The safety control switch is in the Off position.
1. To start the vehicle, press and release the button two times within 2 seconds. The vehicle
will start and remain running for the pre-programmed 5,10, 15, 20 minute run cycle. As
a visual indication, the parking lights will flash or remain on depending on the setting
by your installation center.
2. When you arrive at the vehicle, turn the ignition key to the ON position (not the spring
loaded start position), then step on the brake pedal to disengage the remote starter. The
vehicle will continue to run, but now on it's own power.
NOTE: The engine will stop running before the pre-programmed run cycle has expired if
you perform any one of the following functions;
-Press and release button 2 on the keychain transmitter two times within 2 seconds.
-Depress the brake pedal.
-Open the vehicle's hood
-Move the safety control switch to the Off position.
SAFETY CONTROL SWITCH
The red handle control switch allows you to temporarily disable the remote starting function
of the system and moving this switch to the Off position is recommended whenever the
vehicle is being serviced. When the system is disabled, the remote door locks and optional
accessories will remain operational.
FUNCTION SETTING CHART
To be completed by installer
Door Lock Timer 1 Sec/1 Sec o 3.5 o 1 Sec/Dbl 1 Sec o
Lights Pulse o Steady o
Run Time 5 Min o 10 Min o 15 Min o 20 Min o
© 2000 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, NY 11788 128-5935
1
2