Lay unit on rear panel. Remove floor (PN 10032) from base: Disengage 8 screws/washers

in bottom of base into floor using 7/16” hex driver bit w/drill & pull floor from top of base (will

need to remove lag screws in front / side panels on models noted below using a 3/8” hex

driver bit w / drill). Install floor on base: Set floor on top of base inside unit. (Note: bottom of

floor has (8) screw bosses & rear of floor has slots.) (Will need to install lag screws in

front/side panels on models noted below using a 3/8” hex driver bit w/drill.) Secure floor to

bottom of base using 8 screws PN 22727 with 8 washers PN 11360 into 8 bosses on bottom

of floor.

Remove / Install 8 screws w/washers securing floor to base. Floor can then be pulled

from or placed on base in an assembled unit. Unit with T

-extrusion or HD extrusion

MX3 II

Remove / Install 8 screws w/washers securing floor to base. Also completely remove /

install 6 lag screws in front to base & 1 lag screw on each panel to base (lag screw at

front of left / right side panels) using a 3/8” hex

Taurus