mode – maximum for cleaning of healthy teeth and gum care.
The selected mode can be changed even when cleaning is in process. Activate the appliance by
pressing the ON switch A1. When you press the ON switch again, the appliance will switch off.
For
safety reasons, the appliance will switch off automatically after 2.5 minutes. To restart the appliance,
press the button A1.
Method of use (pic. 4, 5, 6, 7, 8)
As plague which clings to the teeth surface cannot be removed simply with a stream of water, it is
necessary to clean your teeth thoroughly with a toothbrush before using the oral irrigator.
As soon as you have cleaned your teeth replace the brush with the oral irrigator. Turn the nozzle
rotating knob B3 to adjust the direction of the water flow. Slide the handle switch B1 up to start the
water stream. Attach the nozzle D to the oral irrigator and put the nozzle tip between two teeth at
the gum line level at a 90 degree angle. To prevent the water from splashing, press the lips slightly
together around the nozzle, but keep the mouth slightly open so that water can flow out smoothly.
Lean over the washbasin while cleaning your mouth. Slowly guide the nozzle until you feel it settle
between the next two teeth, smoothly follow the gum line and the shape of your teeth. Continue doing
so until you clean all inter-dental spaces, including the molars, in all areas of the mouth. Do not apply
any pressure on the nozzle, let it do all the work on its own. Depending on the selected mode of
cleaning, the full water reservoir C will last for about 100 seconds to 5 minutes.
When cleaning is finished
– Remove the water reservoir C and empty it, pouring any remaining water in the washbasin.
– Switch the oral irrigator on for a few seconds so as to empty the inside as well.
– Wipe all the components with a dry cloth.
Caution
– To avoid proliferation of fungi and bacteria if the appliance is not used for a longer time,
empty the reservoir thoroughly after each use!
– If you are not going to use the oral irrigator for some time, let it dry properly when
disassembled after the last use!
– During the first few days of using the oral irrigator, your gums might bleed slightly but
this usually stops on its own after a few days.
– To ensure the best results when cleaning, we recommend replace every 6 replace
every 6 months the nozzle. However, if the attachment are showing signs of significant
wear or damage, replace theim sooner.
V. MAINTENANCE (pic. 9)
For maximum hygiene, clean the oral irrigator after each use! Failure to do so might result
in deterioration of your state of health due to proliferation of fungi and bacteria. Do not use
any rough and aggressive cleaning agents! The nozzle for teeth and gums D, E, F under running
water. Use the damp cloth to wipe the oral irrigator body B, charging base A. For hygienic purposes
we recommend that you dip the nozzle / tongue scraper into a denture cleaner every 2 – 4 weeks.
Alternatively, you can use other appropriate disinfectants. When using cleaning agents / disinfectants,
always follow the instructions indicated on the packaging. Make sure that the contact surfaces and
sealing elements are clean, not damaged and properly positioned. If you are not going to use the
appliance for an extended period of time, empty the entire water system thoroughly (i.e. empty the
reservoir, press the switch A1/B1, drain the water until it stops flowing from the nozzle).
Other important notes:
– Do not clean the appliance in a dishwasher and do not use any aggressive cleaning agents for cleaning!
– Never use water at a temperature exceeding 50 °C to clean the oral irrigator
– Allow all the appliance components to dry properly before their re-use.
Store the appliance and all the accessories in a dry, dust-free and safe place, out of reach of children
and incapacitated persons. The travel case H is for storing the appliance and attachments.
Replacement attachment D can be purchased under order numbers ETA170890100. These
accessories are not included in box with this product.
GB
20 / 39