18
5. Le site doit être ferme et de niveau. Une position dangereuse peut provoquer
du bruit et des vibrations:
(a) Le bruit peut augmenter si le sol n’est pas solide.
(b) Si vous souhaitez le placer sur un tapis, placez une plaque sous l’appareil pour
dissoudre l’émission de chaleur.
6. Assurez-vous que les pieds réglables sont bien xés et inclinez légèrement
l’appareil vers l’arrière pour maintenir les portes fermées.
MODE D’EMPLOI
Placement de la nourriture
1. Il doit toujours y avoir un espace entre les objets à l’intérieur pour
la circulation de l’air.
2. Les aliments doivent être conservés dans un contenant fermé pour
éviter qu’ils ne se dessèchent ou ne sentent mauvais.
3. Les aliments chauds doivent être refroidis avant d’être placés dans
l’appareil, sinon la température interne et la consommation d’électricité
augmenteront.
4. Réduisez la fréquence d’ouverture de la porte pour réduire
efcacement la consommation électronique.
ATTENTION
N’utilisez aucun équipement électronique dans l’unité.
Instruction d’utilisation
La température du réfrigérateur peut être contrôlée manuellement par le bouton. Ce-
pendant, le numéro sur le bouton n’indique pas directement la température. Au lieu
de cela, plus le nombre est grand, plus la température intérieure est basse. 0 signie
désactivé. 7 représente le niveau de température le plus froid. La température dans
chaque partie sera au plus bas degré en dessous de ce niveau, et elle sera proba-
blement en dessous de 0°C dans la section réfrigérateur, alors choisissez-le avec soin
avant utilisation. Tournez le bouton au niveau 4 s’il est normal, tournez-le au niveau
4-6 si une température intérieure plus basse est requise ; à l’inverse, inférieur à 4-1,
lorsqu’un supérieur est nécessaire.
EMBALLAGE ET DÉMÉNAGEMENT
1. Déballez, remballez et transportez.
Lors du déballage ou du réemballage du produit, rappelez-vous
la position de chaque accessoire de l’appareil et vériez-le
soigneusement avant de le transporter.
2. Ne soulevez pas et ne tirez pas sur la porte ou la poignée de porte
pendant le transport.
3. Lors du déplacement, l’appareil ne doit pas être incliné de plus de 45 degrés
(l’angle par rapport à la direction verticale). Évitez les fortes vibrations et les chocs.
ENTRETIEN
L’appareil doit être entretenu et nettoyé régulièrement. Pour votre sécurité, veuillez
débrancher l’appareil avant de le nettoyer.
1. Entretien intérieur.
Nettoyez l’intérieur de l’appareil avec de l’eau propre ou un détergent neutre.
Frottez l’appareil avec de l’eau propre et essuyez-le avec un chiffon sec.
2. Entretien du joint de porte.
Les joints de porte peuvent être facilement endommagés s’ils sont souillés par des
taches telles que l’huile, la sauce, etc.
3. Entretien de l’extérieur.
Essuyez la poussière avec un chiffon sec, si nécessaire nettoyez-la avec un
détergent neutre.
54
INSTRUCTION FOR USAGE
Unpack , repack and carry
Please memorize the position of each accessory of the appliance
when unpack it, repack the product and check it carefully before
transportation.
Do not lift or pull the door or the door handle during transportation.
When moving, the appliance can not be sloped over 45 degrees
(the angle to the vertical direction). Please avoid strong vibration
and hit.
PACKING AND MOVING
1.
2.
3.
The appliance should be maintained and cleaned frequently. For your safety,do
please pull the plug out of the socket before the cleaning.
Interior maintenance
Clean the interior of the appliance with clean water or neutral abluent.Scour it with
clean water and wipe it with a piece of dry cloth.
Maintenance of door gasket
It is easy to damage if the door gaskets are polluted by the stain like oil, sauce and
etc., so it is better to clean them carefully.
Outer maintenance
Wipe the dusty with a piece of dry cloth ,clean it with neutral abluentif necessary.
MAINTENANCE
1.
2.
3.
Do not use any electronic equipment inside the appliance.
Warning
The refrigerator should be located in a completely flat surface , Leave 5~10 cm
between each side of the appliance and the wall, and leave 30 cm between the top
of the appliance and the ceiling.
Choose a location which is not exposed to sunlight ,
high temperature or humid , as humidity maycause stain.
Pulled out the bottom panel before installation.
The appliance can be adjusted by rolling its two legs in
front the bottom when it is unstable. Rolling in clockwise
can rise up the machine.
The location should be firm and flat. An un-securely
position may cause noise and libration:
(a)The noise may be increased if the floor is not firm.
(b) Put a sheet under the appliance for solving the heat
emission if you need to locate it onto a carpet.
Make sure the adjustable legs are clung to the floor,
and set the appliance slope backward slightly for keeping the doors closed tightly.
PLACEMENT OF FOOD
INSTALLATION INSTRUCTIONS
OPERATION INSTRUCTIONS
1.
2.
3.
4.
5.
6.
There should always be some space between items inside for air circulation.
Food should be to avoid becoming
dry or with odour.
kept in sealed package
Hot food should be cooled down before placing into the
appliance. Otherwise, interior temperature and electronic
consumption will increase.
Reduce the frequency of door opening can efficiently low
down the electronic consumption.
1.
2.
3.
4.
The temperature of refrigerator can be controlled manually by the
knob. However, the number shown on the knob does not directly
represent the temperature. Instead, the larger the number is, the lower
the interior temperature will be. 0 stands for off. Turn the knob to state
4 when it is normal used, turn it to the state during 4-7 if a lower interior
temperature is required; contrarily, to the state during 4-1, when a
higher one is needed.
54
INSTRUCTION FOR USAGE
Unpack , repack and carry
Please memorize the position of each accessory of the appliance
when unpack it, repack the product and check it carefully before
transportation.
Do not lift or pull the door or the door handle during transportation.
When moving, the appliance can not be sloped over 45 degrees
(the angle to the vertical direction). Please avoid strong vibration
and hit.
PACKING AND MOVING
1.
2.
3.
The appliance should be maintained and cleaned frequently. For your safety,do
please pull the plug out of the socket before the cleaning.
Interior maintenance
Clean the interior of the appliance with clean water or neutral abluent.Scour it with
clean water and wipe it with a piece of dry cloth.
Maintenance of door gasket
It is easy to damage if the door gaskets are polluted by the stain like oil, sauce and
etc., so it is better to clean them carefully.
Outer maintenance
Wipe the dusty with a piece of dry cloth ,clean it with neutral abluentif necessary.
MAINTENANCE
1.
2.
3.
Do not use any electronic equipment inside the appliance.
Warning
The refrigerator should be located in a completely flat surface , Leave 5~10 cm
between each side of the appliance and the wall, and leave 30 cm between the top
of the appliance and the ceiling.
Choose a location which is not exposed to sunlight ,
high temperature or humid , as humidity maycause stain.
Pulled out the bottom panel before installation.
The appliance can be adjusted by rolling its two legs in
front the bottom when it is unstable. Rolling in clockwise
can rise up the machine.
The location should be firm and flat. An un-securely
position may cause noise and libration:
(a)The noise may be increased if the floor is not firm.
(b) Put a sheet under the appliance for solving the heat
emission if you need to locate it onto a carpet.
Make sure the adjustable legs are clung to the floor,
and set the appliance slope backward slightly for keeping the doors closed tightly.
PLACEMENT OF FOOD
INSTALLATION INSTRUCTIONS
OPERATION INSTRUCTIONS
1.
2.
3.
4.
5.
6.
There should always be some space between items inside for air circulation.
Food should be to avoid becoming
dry or with odour.
kept in sealed package
Hot food should be cooled down before placing into the
appliance. Otherwise, interior temperature and electronic
consumption will increase.
Reduce the frequency of door opening can efficiently low
down the electronic consumption.
1.
2.
3.
4.
The temperature of refrigerator can be controlled manually by the
knob. However, the number shown on the knob does not directly
represent the temperature. Instead, the larger the number is, the lower
the interior temperature will be. 0 stands for off. Turn the knob to state
4 when it is normal used, turn it to the state during 4-7 if a lower interior
temperature is required; contrarily, to the state during 4-1, when a
higher one is needed.
54
INSTRUCTION FOR USAGE
Unpack , repack and carry
Please memorize the position of each accessory of the appliance
when unpack it, repack the product and check it carefully before
transportation.
Do not lift or pull the door or the door handle during transportation.
When moving, the appliance can not be sloped over 45 degrees
(the angle to the vertical direction). Please avoid strong vibration
and hit.
PACKING AND MOVING
1.
2.
3.
The appliance should be maintained and cleaned frequently. For your safety,do
please pull the plug out of the socket before the cleaning.
Interior maintenance
Clean the interior of the appliance with clean water or neutral abluent.Scour it with
clean water and wipe it with a piece of dry cloth.
Maintenance of door gasket
It is easy to damage if the door gaskets are polluted by the stain like oil, sauce and
etc., so it is better to clean them carefully.
Outer maintenance
Wipe the dusty with a piece of dry cloth ,clean it with neutral abluentif necessary.
MAINTENANCE
1.
2.
3.
The appliance is equipped with a screwing lamp or a long life LED interior light.
(Screwing lamp can be replaced by professionals.Long life LED is non-replaceable).
4.
Do not use any electronic equipment inside the appliance.
Warning
The refrigerator should be located in a completely flat surface , Leave 5~10 cm
between each side of the appliance and the wall, and leave 30 cm between the top
of the appliance and the ceiling.
Choose a location which is not exposed to sunlight ,
high temperature or humid , as humidity maycause stain.
Pulled out the bottom panel before installation.
The appliance can be adjusted by rolling its two legs in
front the bottom when it is unstable. Rolling in clockwise
can rise up the machine.
The location should be firm and flat. An un-securely
position may cause noise and libration:
(a)The noise may be increased if the floor is not firm.
(b) Put a sheet under the appliance for solving the heat
emission if you need to locate it onto a carpet.
Make sure the adjustable legs are clung to the floor,
and set the appliance slope backward slightly for keeping the doors closed tightly.
PLACEMENT OF FOOD
INSTALLATION INSTRUCTIONS
OPERATION INSTRUCTIONS
1.
2.
3.
4.
5.
6.
There should always be some space between items inside for air circulation.
Food should be to avoid becoming
dry or with odour.
kept in sealed package
Hot food shou ld be cooled do wn before placing i nto th e
appliance. Otherwise, interior temperature and electronic
consumption will increase.
Reduce the frequency of door opening can efficiently low
down the electronic consumption.
1.
2.
3.
4.
The temperature of refrigerator can be controlled manually by the knob. However,
the number shown on the knob does not directly represent the temperature. Instead,
the larger the number is, the lower the interior temperature will be. 0 stands for off. Turn
the knob to state 4 when it is normal used, turn it to the state during 4-7 if a lower interior
temperature is required; contrarily, to the state during 4-1, when a higher one is needed.