Tilton Cerametallic Discs Instrukcja instalacji
- Typ
- Instrukcja instalacji
InstallatIon
Install the plates and discs into the clutch (Diagram A) in the following manner:
Make sure to check the following:
Cerametallic Rally Clutch Discs
INSTALLATION INSTRUCTIONS
98-1347
Tilton Engineering, Inc. 25 Easy Street • PO Box 1787 • Buellton, CA 93427 • www.tiltonracing.com
Diagram A
MaIntenance
DIscs
Clutch discs start new at .283" thick. These should be replaced when the total pack wears .030". This means the individual disc thickness should not be less
than:: Single disc = .253" | Two disc = .268"
Note: The friction material used on these discs is wear resistant. It will typically wear quickly for the rst .002" of disc thickness, and
then wear much slower after that.
Pressure Plate anD Floaters
Check the plates periodically for warping. This warping is caused by heat put into the clutch from slipping. Check warping with a straightedge and feeler
gauges. Maximum allowable warping is .008" in any plate. Pressure plates can be resurfaced to a minimum thickness of .525" (after surfacing). Floater plates
should never be resurfaced. Be sure to align the balance marks when reinstalling the plates.
CAUTION: Never put new discs into a clutch that has a warped pressure plate or oater plates. There will not be full contact across
the face of the discs and they will wear out quickly. On the same note, discs that were used in a clutch with a warped pressure plate or
oater plates should never be used in a new clutch assembly.
• Hubs make full spline contact with
input shaft
• There is clearance between hubs
(and rivets)
• There is clearance between the
bottom disc and ywheel bolts
Note: Friction pads should be stacked over each other as shown in Diagram A and not staggered.
sIngle DIsc clutch asseMbly
Contains “V” or “W” in the part #.
1. Install pressure plate with raised ring against diaphragm.
2. Install disc #1 (V or W hub) with TE logo on rivet heads
towards the ywheel.
Dual DIsc clutch asseMbly
Contains “VV” or “VW” in the part #.
1. Install pressure plate with raised ring against diaphragm.
2. Install disc #1 (V hub) with TE logo on rivet heads
towards the ywheel.
3. Install oater plate.
4. Install disc #2 (V or W hub) with TE logo on rivet heads
towards the ywheel.
V = Solid, 8 rivet, outer (.375" thick)
W = Solid, 8 rivet, outer (.550" thick)
VVV W V W
FLYWHEEL
CLUTCH COVER
-
1
