Yamaha KP120 Instrukcja obsługi

Marka: Yamaha

Model: KP120

Typ: Instrukcja obsługi

LEVEL

VEL

LEVEL

KP120 Main Unit

Riser

Legs

LEVEL

LEVEL Adjustment Knob

LEVEL

Drum Head

Hoop

Shell

Riser

Wing Bolt for Riser

Bottom Cover

OUTPUT Jack

Adjustment Bolt

Wing Bolt

for Legs

Legs

Leg Rubber

OWNER’S MANUAL

INTRODUCTION

Thank you for purchasing the YAMAHA Real Head Kick Pad KP120. The YAMAHA

Real Head Kick Pad was developed as the bass drum trigger pad for use with an

electric drum system. For its head, the kick pad utilizes Remo Coated Ambassador

heads. The system delivers a richer, closer to acoustic feeling that extends greater

expressive potential to the drummer. Just like a real, high quality acoustic drum, the

shell is made of birch then covered with a clear finish.

To get the most out of your YAMAHA Real Head Kick Pad KP120, please read this

manual carefully. After reading, please keep this manual in a safe place for future

reference.

• Do not disassemble (except for when replacing the head or a cushion as described in this manual) or alter the

product. Doing so may result in damage or deterioration to the product.

• Do not step on or place heavy objects on the product. It may result in damage.

• Do not use or keep the product in places with extremely high temperature (places in direct sunlight, close to a

heater, in a closed car, etc.) or damp (bathroom, outside on a rainy day, etc.). It may result in deformation,

discoloration, damage or deterioration.

• To clean the product, please wipe with a soft cloth or a damp cloth that has been wrung out thoroughly. If the

product is soiled, use a neutral detergent on a cloth then wipe with a damp cloth that has been wrung out

thoroughly to remove any remaining detergent. Do not use benzine, thinner or alcohol as it may result in

discoloration or deformation. Also pay close attention so as not to let the water and detergent come into

contact with the cushions used in the product, it may result in deterioration.

• When connecting and disconnecting cables, make sure you hold the cable by its plug. Also, please make sure you

never place heavy or sharp objects on the cable. Excessive force applied to the cable may result in troubles such as

shorted cables, etc.

■ Handling Precautions

Before setting up, please make sure that all of the items listed below are present and ac-

counted for. If anything is missing, please contact the dealer from whom you purchased the

unit.

■ Inside This Package

• KP120 Unit (including Leg x2, Riser x1) x1

• Monaural Phone Cable (3m) x1

■ Part Names (When Assembled)

Controls the trigger output level produced by the

KP120. Turn the LEVEL adjustment to the right

(+) to increase the level. Turn to the left (-) to de-

crease the level. Adjust the level according to the

amount of strength you use when playing, the

required dynamic range, or specific needs regard-

ing the devices that you use.

■ Output Level (LEVEL) Adjustment

NOTE : When the KP120 is used with the DTXTREME/DTX/

DTXPRESS, the value on the Input Level display,

found in the Trigger Edit Mode’s [PAD GAIN] page,

should be set somewhere between 90% and 95%

when the pad is struck at ff. For more information,

please refer to the “Owner’s Manual” supplied with

your DTXTREME/DTX/DTXPRESS.If the Output

Level is set too high, the dynamic range may be

reduced, or result in problems such as double

triggers (when a single stroke produces multiply

triggered sounds).

: Do not exert excessive force on the level

adjustment knob. Doing so may result in damage.

To Increase the Sound Volume

To change the volume of the sound assigned to the KP120, when the KP120 is used with the

DTXTREME/DTX/DTXPRESS, first adjust the Output LEVEL as described previously, then use

the (VOICE) EDIT mode to set the volume on the DTXTREME/DTX/DTXPRESS. Please refer to

the “Owner’s Manual” supplied with your DTXTREME/DTX/DTXPRESS.

Just as on acoustic drums, the KP120’s drum head will need to be replaced in time. When the

head’s condition deteriorates, please replace the head with a new head by yourself (we rec-

ommend Remo Coated Ambassador 12" drum heads). Other than the recommended drum

head, you can use any drum head you prefer but, when a drum head that is different from the

supplied or recommended drum head is used please understand that the feeling, sound,

output level, etc. may be slightly different.

■ Replacing the Drum Head

NOTE : For sensing and sound dampening purposes,

the KP120 utilizes a cushion that gives support to

the drum head from within the pad. When replacing

the drum head, make sure the cushions are

positioned in the same manner as when the unit was

shipped from the factory. The yellow cushion is

placed on the bottom while the three gray cushions

with holes are positioned so as the holes, other than

the center hole, are staggered. Improper

positioning of the cushions may alter the pad’s feel,

sound and output.

■ About Replacing Worn Parts

(Cushion, etc.)

• This product uses parts (drum head, cushion, Output Level Adjustment knob, output jacks,

etc.) that will wear or deteriorate over time. How these parts wear or deteriorate will de-

pend upon the environment, length of time, etc. that the device is used.

• Please ask the dealer from whom you purchased the device about replacing the parts.

Lug

Tuning Bolt

Leg Rod

Beater (Double Pedal)

Tuning Bolt

Hoop

LEVEL

Wing Bolt for

Legs

Washer

Spring Washer

Wing Bolt for Riser

Wing Bolt for

Legs

Washer

Spring Washer

LEVEL

Legs

Loosen

Adjustment

Bolt

Extend

Beater

Non-Slip Spur

Leg Rubber

SPECIAL MESSAGE SECTION

NOTICE: Service charges incurred due to a lack of knowledge relating to how a function or effect works (when the unit is operating as designed) are not covered by the

manufacturer’s warranty, and are therefore the owners responsibility. Please study this manual carefully and consult your dealer before requesting service.

ENVIRONMENTAL ISSUES: Yamaha strives to produce products that are both user safe and environmentally friendly. We sincerely believe that our products and the

production methods used to produce them, meet these goals. In keeping with both the letter and the spirit of the law, we want you to be aware of the following:

Battery Notice: This product MAY contain a small non-rechargeable battery which (if applicable) is soldered in place. The average life span of this type of battery is

approximately five years. When replacement becomes necessary, contact a qualified service representative to perform the replacement.

This product may also use “household” type batteries. Some of these may be rechargeable. Make sure that the battery being charged is a rechargeable type and that

the charger is intended for the battery being charged.

When installing batteries, do not mix batteries with new, or with batteries of a different type. Batteries MUST be installed correctly. Mismatches or incorrect installation

may result in overheating and battery case rupture.

Warning: Do not attempt to disassemble, or incinerate any battery. Keep all batteries away from children. Dispose of used batteries promptly and as regulated by the

laws in your area. Note: Check with any retailer of household type batteries in your area for battery disposal information.

Disposal Notice: Should this product become damaged beyond repair, or for some reason its useful life is considered to be at an end, please observe all local, state, and

federal regulations that relate to the disposal of products that contain lead, batteries, plastics, etc. If your dealer is unable to assist you, please contact Yamaha directly.

NAME PLATE LOCATION: The name plate is located on the bottom of the product. The model number, serial number, power requirements, etc., are located on this plate.

You should record the model number, serial number, and the date of purchase in the spaces provided below and retain this manual as a permanent record of your purchase.

Model Serial No.

Purchase Date

PLEASE KEEP THIS MANUAL

■ Specifications

■ Setting Up

* A drum tuning key will be required for assembly.

1. Assemble the KP120. As shown in the

illustrations, remove the wing bolts and

attach the riser and legs. Use the tuning

key to loosen the adjustment bolts, then

extend the four legs and tighten the bolts

loosely.

2. Attach your foot pedal to the KP120.

Adjust the legs so that the surface of the

KP120’s pad is vertical when the foot

pedal is attached and the kick pad and

pedal are stable when the pedal is used

to strike the pad. After leg length has been

determined, tighten the bolts firmly to

secure.

3. Make slight adjustments to the pedal’s position and the beater length so that beater strikes

the pad at its center.

NOTE : A double foot pedal setup (YAMAHA: DFP-880, etc.) can also be used. When a double foot pedal setup is

used on the KP120, the position of the pedal and length of the beaters should be adjusted so that the point

between the two beaters is positioned at the pad’s center.

NOTE : Use the legs with their non-slip spurs at the ends of the legs exposed, if the drum is setup on a platform or

marks on the floor are no problem. If you don’t want to leave marks on the floor, use the legs with the spurs

at the ends of the legs covered with the rubber ends.

NOTE : Drum head tension can be adjusted by tightening or loosening the tuning bolts on the hoop with a drum key.

However, there will be no change in the tone produced by the DTXTREME/DTX/DTXPRESS, etc.

NOTE : Please make sure that head tension is even all the way around the head. Uneven tension may produce

wrinkles, which may shorten the life of the drum head.

NOTE : Never tighten or loosen the drum head more than necessary. Over tightening may result in damage to the

drum head, shell, etc. An overly loosened head may result in a shorter life of the drum head, cushion, or noise.

Use the supplied monaural phone cable to con-

nect the pad’s OUTPUT jack to the Input (KICK,

etc.) jack on the DTXTREME/DTX/

DTXPRESS. Connect the cable’s L-shaped

plug to the pad.

NOTE : When the KP120 is used with the DTXTREME/

DTX/DTXPRESS, please set the INPUT’s “Pad

Type” setting to “RH Kick” on the DTXTREME,

“pad 2” on the DTX, or “KP” on the DTXPRESS.

Selecting another pad type may result in

problems such as double triggers (when a single

stroke produces multiply triggered sounds). Please

refer to the “Owner’s Manual” supplied with your

DTXTREME/DTX/DTXPRESS.

■ Connections

3m Cable with Standard Phone

Plug (monaural)

Connect

If the following trouble occurs when the KP120 is used, please check the following points

before asking your dealer for assistance.

■ Troubleshooting

Pad Diameter 12 inches

Size (when setup including protrusions) 530(W)x330(D)x510(H)mm

Weight 5,310g

Sensor System Single Trigger Type

Control Output LEVEL Volume x1

Output Jack Standard Monaural Phone Jack

Accessories Monaural Phone Cable (3m) x1, Owner’s Manual (this booklet) x1

* Improvements may result in a change in the specifications and/or design of the product without notice.

Riser

Beater

● No sound output, sound level is low

Problem

Is the KP120’s OUTPUT jack properly connected

to the INPUJT jack of the DTXTREME/DTX/

DTXPRESS with the supplied cable?

Is the KP120’s Level Adjustment Knob set lower

than necessary?

Is the DTXTREME/DTX/DTXPRESS properly con-

nected to an external device such as a pair of head-

phones, amplifier, speaker, etc?

Is the DTXTREME/DTX/DTXPRESS properly

setup?

What to check.

Check the connections between the KP120 and the

DTXTREME/DTX/DTXPRESS.

When the Level Adjustment Knob is set lower than nec-

essary, even though the pad may have been hit hard,

only a weaker signal is sent so the tone generator in the

DTXTREME/DTX/DTXPRESS will not be able to pro-

duce sufficient volume.

Check the connections between the external devices

and also the power switch, volume, etc. settings on the

external device.

Make sure the volume setting assigned to the INPUT

number on the DTXTREME/DTX/DTXPRESS to which

the KP120 is connected is not set too low (refer to the

previous “Increase the Volume” section) or the

headphone’s volume is set too low.

●

Multiple sounds are produced when the pad is struck once (Double Trigger).

Problem

Is the KP120’s Output LEVEL adjustment knob

set too high?

Is the Input Pad Type to which the KP120 is con-

nected to the DTXTREME/DTX/DTXPRESS set

to a pad type other than “RH Kick” on the

DTXTREME, “pad 2” on the DTX, or “KP” on the

DTXPRESS?

What to check.

If the Output LEVEL knob is set too high, the large sig-

nal remains for a longer time causing the DTXTREME/

DTX/DTXPRESS to produce multiple triggers. Use the

previously explained Output LEVEL adjustment to set

the level to a proper level.

Even if the signal level is the same, if the pad type is set

to a different pad type, double triggers

might easily occur. Refer to the Owner’s Manual sup-

plied with the DTXTREME/DTX/DTXPRESS

for more information.

❇ If the double triggers continue even after you have tried the solutions listed above, use the DTXTREME/DTX/

DTXPRESS “Self Rejection” function to control the problem. Refer to the Owner’s Manual supplied with the

DTXTREME/DTX/DTXPRESS for more information.

For more information on the problems listed above and other problems, please refer to the “Owner’s

Manual” of the DTXTREME/DTX/DTXPRESS. If you cannot solve the problem on your own, please contact

the dealer from whom you purchased the device.

Yamaha KP120 Instrukcja obsługi

Marka: Yamaha

Model: KP120

Typ: Instrukcja obsługi

ściągnij PDF

raport

w innych językach

čeština: Yamaha KP120 Návod k obsluze
español: Yamaha KP120 El manual del propietario
italiano: Yamaha KP120 Manuale del proprietario
Deutsch: Yamaha KP120 Bedienungsanleitung
svenska: Yamaha KP120 Bruksanvisning
português: Yamaha KP120 Manual do proprietário
français: Yamaha KP120 Le manuel du propriétaire
日本語: Yamaha KP120 取扱説明書
Türkçe: Yamaha KP120 El kitabı
English: Yamaha KP120 Owner's manual
dansk: Yamaha KP120 Brugervejledning
русский: Yamaha KP120 Инструкция по применению
Nederlands: Yamaha KP120 de handleiding
română: Yamaha KP120 Manualul proprietarului

Yamaha KP120 Instrukcja obsługi

Yamaha KP120 Instrukcja obsługi

w innych językach

Powiązane dokumenty