Strona się ładuje...
Instructor-Side Locking Door
for Inspiration Lectern
#55405
Assembly Instructions:
Tools Required:
Phillips screwdriver
Before you begin, please make sure all parts and proper quantities are
included. Any parts damaged during shipment must be reported within
15 days of receipt. To report information regarding damages or if you
have any questions, please call 1-800-235-1262.
1. Attach Door
A. Install the two pieces of edge trim on the lock-side of the door about 1" from the top and bottom
as shown in Figure 1.
B. Align and attach the door to the right side panel mounting holes with (5) 8-32 x 1/2" PH thread
cutting screws and tighten securely. Figure 1.
Note: If you are using a drill driver, be careful not to over-tighten
the screws as this could damage the threads
To purchase parts or accessories, please contact us at
www.spectrumfurniture.com
1-800-235-1262
Thank you for choosing Spectrum products!
(5) 0100167
8-32 x 1/2" PH thrd ctg
screw
(2) 0109914
3" edge trim
Right side
panel
(2) 026296
Recessed Bumper
w/ washer
(2) 037542
#8 x 5/8" PHSM
screw
0109742R1 Page 1 of 2
Figure 1
8-32 x 1/2"
thrd ctg
screws
(5 req'd)
Edge Trim
Door
Right side
panel
Edge Trim
0109742R1
P
age
1
o
f
2
A. With the door closed, remove the existing upper and lower PHM screws
from the right side panel.
B. Install a bumper in each open mounting hole location with a
#8 x 5/8" PHSM screw. Figure 2.
2. Install Door Bumpers
Bumper w/
Recessed Washer
#8 x 5/8" PHSM
Right side panel
Note: On 42"H lecterns, the upper bumper will be
installed in the mounting hole 2nd from the top.
0109742R1 Page 2 of 2
Figure 2
Bumper w/
Recessed Washer
#8 x 5/8" PHSM
0109742R1
Page
2
of
2
1/2