Ventev 14x12x6 NEMA 4X Instrukcja obsługi

w w w.ventev.com/infra sales@ventev.com 800.851.4965

Instructions-14x12x6 NEMA 4X Enclosure

with Integrated Directional Antenna

•Attach the mounting feet to the enclosure and hang enclosure in the desired location.

•Install the included cable gland on the box and run ethernet cable in.

•This enclosure accommodates the 9130E access point. Orient the Cisco low profile bracket in

orientation

•Attach mounting bracket to the back plate using QTY (4) #8 screws. See Figure 1. The right 2

screws will need to be removed from the antenna swing out panel to allow access to the back

plate.

Figure 1.

•Plug in the ethernet cable and then slide the access point into the mounting bracket.

Figure 2.

•Connect the DART cable that is attached to the installed antenna on the separate swing out panel.

•Replace the 2 screws to hold down the antenna swing out panel.

ściągnij PDF