| Install batteries
Slide off the cover case of the
battery room, and put into 2
AAA batteries. Then slide the
cover case back.
| Setting capacity
and timing
I®
DISPLAY
RESET
Keep pressing |
button, then press |
button and release both of the buttons. The DigiFlow
8000T will go into setting procedure. The digit will flash
to notice you that the setting procedure is on.
> Setting capacity
Press IW M ilia fl button to choose the
capacity. The sequence is 0 - 100 -
200 - 300...9800 - 9900 - OFF - 0 -
100. Then press is ia a a a button to save
the filter capacity value. Then go into
timing setting.
*The capacity mode will be disabled when you choose OFF.
» Setting timing
Press lilb ld fe V l button to choose the timing.The
sequence is 0 - 30 - 60 - 90...690 - 720 - OFF - 0 - 30.
Then press to save the Timing. The setting
procedure is completed.
*The capacity mode will be disabled when you choose OFF.
*The setting procedure will be terminated, and go back to
DigiFlow 8000T
User’s Manual
the original status if there is no input for 10 seconds.
| Connecting fitting
The specification of the DigiFlow
8000T connectors is 3/8” NPT
female. You could use any 3/8”
NPT male connectors.
| Operating
The DigiFlow 8000T will be automatically on when there
is any water flowing through the sensor. It will automati
cally off when there is no water flowing for 10 seconds .
DISPLAY
Press DISPLAY
button:
| button is to display the status of the
three modes of the DigiFlow 8000T. showing the capaci
ty left. Timing mode:showing the tiniing left.Flow rate
mode:showing the current flow rate. The sequence is
Flow-Rate-Timing-Capacity...
RESET
button:
Press
setting-
RESET
button is to reset the setting to be the last
g/m
Alarm
» Noticing Alarm
When capacity is lower than 30 gallons or timing is
lower than 7 days, the buzzer will beep once and the
digit will flash to notice you to prepare changing filter
cartridge when there is any water flowing through
DigiFlow 8000T or press the
DISPLAY button.
> Warning Alarm
When capacity reaches 0 gallon or timing reaches 0
day, the buzzer will beep twice and the digit will flash to
notice you to change the filter changing when there is
any water flowing through DigiFlow 8000T or press the
DISPLAY
» Low battery power alert
When the battery power lower than normal working
level, the buzzer will beep twice to notice you to change
thed the battery.
The data will be kept in memory when the battery power
is run out or battery is removed.
-
1
-
2
-
3
-
4
w innych językach
- English: Savant DigiFlow 8000T User manual
Inne dokumenty
-
Yamaha PSR-600 Instrukcja obsługi
-
-
-
-
-
-
-
-
Hydrologic Purification Systems ⅜" Flowmaster Instrukcja obsługi
