SoundTube Mighty Mite Instrukcja instalacji

SoundTube
Marka
SoundTube
Model
Mighty Mite
Kategoria
Mocowania głośników
Typ
Instrukcja instalacji
MM43-BGM & MM32-EZ
Tap location
Box contents
1 Speaker
2 SpeedClamps™
1 Release key (small hex wrench)
1 Hanging cable
1 Safety cable
4 Zip ties
Tap switch
© 2021 MSE Audio SoundTube Entertainment, Inc. All rights reserved. PN INS-MM Rev 11.15.21
UL Listed 1480A
1.855.663.5600
|
www.soundtube.com
Do not spec or install speaker near support beam, ventilation duct or
other structure that may interfere with speaker function or dispersion.
Warning Warning
SoundTube speakers must be installed by a professional audio installer/contractor. For safety and for
optimum audio performance, installer must follow all directions issued by SoundTube Entertainment.
MM43-BGM and MM32-EZ speakers
Mighty Mite
™
byby
Safety cable with clip Hanging cable with clip
Hanging or safety cable
Secure anchor point
SpeedClamp™
Transformer Taps
70.7 V
30 W
15 W
7.5 W
3.75 W
Output
98.5 dB
95.5 dB
92.5 dB
89.5 dB
100 V
30 W
15 W
7.5 W
Output
98.5 dB
95.5 dB
92.5 dB
© 2021 MSE Audio SoundTube Entertainment, Inc. All rights reserved. PN INS-MM Rev 11.15.21
10. Use zip or twist-lock ties
to secure safety cable & signal
wire to main hanging cables.
Cable cover available for
asthetic applications (SLT-10).
7. Adjust speaker hanging
height with SpeedClamp™
mechanism. Pull to tighten &
insert release key (small hex
wrench) into SpeedClamp ™
as shown to loosen or adjust.
6. Thread cable end(s)
through SpeedClamp™
mechanisms as shown.
5. Attach the hanging cable
by securing it and the safety
cable to structure as shown.
8. Attach hanging cable to
the center hole in the
speaker hanging bracket.
MM43-BGM and MM32-EZ speakers
Mighty Mite
™
byby
1.855.663.5600
|
www.soundtube.com
9. Attach the safety cable to
one of the secondary holes in
the hanging bracket.
4. Thread hanging or safety
cable through SpeedClamp™
mechanisms as shown.
2. Connect signal wire to
screw-down terminal block.
Tighten unused terminal
screws. Use inside positive
and negative inputs for
either voice coil or
distributed systems.
Source
3. When daisy chaining, wire
the outside terminals to the
inside terminals of the next
speaker. This step only applies
to tap settings using the
transformer and not when the
speaker is used on bypass.
1. Remove the
magnetically-attached grille
from the front of the speaker to
reveal the rotary tap switch.
Select tap position on rotary
switch. Switch is preset to
maximum tap setting in 70.7V
mode.
  • Page 1 1
  • Page 2 2

SoundTube Mighty Mite Instrukcja instalacji

SoundTube
Marka
SoundTube
Model
Mighty Mite
Kategoria
Mocowania głośników
Typ
Instrukcja instalacji
ściągnij PDF
raport

w innych językach

Inne dokumenty