IM022
www.scarlett.ru SC-JE50S53
HOW TO ASSEMBLE
DISMANTLING:
Unplug the appliance from the power supply.
Open the locks.
Remove the transparent lid, pull the grating filter upwards, then take off separating unit. While
doing this, hold it by the beak from below and by the underside of the top of the unit on the
other side.
ASSEMBLING:
Place the separating unit on the motor unit, push with both hands on the separating unit until it
clicks into place.
Insert the grating filter; turn it clockwise to fit securely.
Mount the transparent lid and fasten the locks.
Place the pulp container under the cover, and the glass – under the beak for juice.
Install the demountable foam separator in the glass. It serves to remove foam from juice while
it is being poured.
Plug the appliance to the power supply.
OPERATING INSTRUCTIONS
This appliance is equipped with a safety system. If the cover is not correctly placed or the
locks are unfastened, the appliance will not function.
Turn the anti-drop nozzle with the hole facing down.
ATTENTION! Do not turn on the juicer if the anti-drop nozzle is turned up with the opening.
This may cause the device's engine to fail.
The position of the anti-drop nozzle with the opening up is used to prevent residual juice drops
from falling on the table.
Before starting make sure that the juicer is switched off and transparent lid fixed properly.
Wash fruits and vegetables thoroughly. Cut fruits into small pieces so as to be fitted into the
feeding tube. Remove the stone or peel from those citrus and fruit: prunes, apricots, cherries
or oranges, lemons, melons, etc.
Place a juice jug under spout.
Plug cord into the wall socket. Switch on the appliance and choose desired speed:
Speed I: for soft foods (pears, strawberries, oranges, plums, grapefruit, lemon, grapes,
marrows and pumpkins, cherries, onions, cucumbers, garlic).
Speed II: for hard foods (artichokes, carrots, fennel, apples, beets, potatoes, pineapple,
cabbages, leeks, celery, spinach).
P – pulse mode of operation: the juicer works while the speed switch is held in the "P"position.
Feed the pre-prepared fruits and vegetables into the juice extractor and press down gently
with the pusher. NEVER USE FINGERS AS PUSHER.
The motor must always be running after fruit or vegetables were fed into the appliance.
When pulp container or juice jug is full, switch off the power and empty containers before
continuing the process.
CAUTION:
The juice extractor cannot process bananas, peaches, apricots, mangos, papayas, etc.
The juice extractor cannot process coconuts or other hard food.
When process is completed, switch off and unplug the unit.
CLEANING
Remove and wash all removable parts in warm soapy water. Rinse filter assembly from under
side for easy removal of residue from strainer holes. Do not use a dishwasher or very hot
water.
Do not use steel woods, abrasive cleaners or scouring pad on appliance.
To clean the outside of the motor unit, use a damp sponge.
Never immerse the body in water.
Some vegetables, such as carrots, may cause discoloration of the plastic. Reduce this by
washing parts immediately after use with small amount of non-abrasive cleaner on a cloth, rub
gently, then rinse well and dry.