Spanner
reserve water outlret
B
cold and hot water valve
A
cold and hot water valve
C
cold and hot water valve
D
cold and hot water valve
1.After placing the bathtub in the reserved position,use
the spirit level to adjust the support nut until the bathtub
is placed horizontally. Please keep a gap of 3-5mm
between the edge of the bathtub and the wall
PencilSpirit level
21 3
Tapeline
4
W/2
H
INSTALLATION MANUAL
STEP 3
STEP 1 STEP 2
STEP 4
1.Before installation,please confirm the installation position
of bathtub,reserve the position of hot and cold water valve
and water outlet.
1.Insert the outlet pipe into the sewer pipe.If the outlet
pipe is too short,Please connect it with a tube before
inserting.
Notes on the usage of freestanding bathtub
1.Please do not hit the bathtub with hard objects or drop hard objects from the elevation
into the bathtub.
2.No adding boiling water directly into the bathtub.Please put cold water first,then hot
water.Pay attention to avoiding storing bathtubs above 80 degrees,because acrylic
products will begin to soften when heated at 100 degrees
3.Power-on bulb,naked flame,high temperature object,please do not place them in the
bathtub,otherwise it will leave scars or cause deformation of the bathtub.Strong organic
solvent such as paints,volatile agents,thinners,please do not contact with bathtub to avoid
surface softening,dissolution,cracking,ect,which may endanger product quality.
4.Avoid wiping with cleanser.Cleanser will corrode the surface and reduce brightness.
5.The hardness of acrylic is equivalent to aluminum,so please pay attention to the surface
protection.It's inevitable that the surface of bathtubs will be scratched in the daily use of
friction.It can be repaired with above 1500# abrasive paper,and the bright surface can be
obtained with automotive polishing agent.
Please wipe off the surface with a cloth which is dry and soft to keep the bathtub clean.
L/2
-
1
