before plugging in
l
Make sure your electricity supply is
the same as the one shown on the
underside of your toaster.
Important – Plug and Fuse
Information
l
The wires in the cord are coloured
as follows:
Green and Yellow = Earth,
Blue = Neutral,
Brown = Live.
l
If the plug supplied with your
appliance has a fuse fitted it is rated
either 10A or 13A. If the fuse fails
it must be replaced with one of the
same rating.
l
If the plug or cord requires replacing
a new cord set should be fitted by
an Authorised Kenwood Repairer.
l
WARNING: THIS APPLIANCE
MUST BE EARTHED.
Note:
l
For non-rewireable plugs the fuse
cover MUST be refitted when
replacing the fuse. If the fuse
cover is lost then the plug must
not be used until a replacement
can be obtained. The correct fuse
cover is identified by colour and a
replacement may be obtained from
your Kenwood Authorised Repairer
(see Service).
l
If a non-rewireable plug is cut
off it must be DESTROYED
IMMEDIATELY. An electric shock
hazard may arise if an unwanted
non-rewireable plug is inadvertently
inserted into a 13A socket outlet.
l
This appliance conforms to EC
Regulation 1935/2004 on materials
and articles intended to come into
contact with food.
before using for the first time
1 Wrap excess cord around the cord
storage device on the underside of
the toaster 1.
l
Operate the toaster once on a
medium setting without bread. (The
lever will not stay down unless the
toaster is plugged in).
l
As with all new heating elements,
your toaster may emit a slight
burning smell when it is first
switched on. This is normal and not
a cause for concern.
Use the carriage lever to lift the toast
to Peek & View™ at any time
without cancelling the toasting cycle.
key
a warming rack selector
(TTP220 /TTP230)
b warming rack (TTP220/TTP230)
c Peek & View™ carriage lever
(with ‘Hi-Rise™’ for extra lift)
d browning control
e reheat button with indicator light
f defrost button with indicator light
g cancel button with indicator light
h crumb tray
i cord storage
to use your toaster
1 Plug the toaster into the power
supply.
2 Move the browning control to the
desired setting. Use a low setting
for light toasting and for thin or dry
bread.
3 Insert the bread, muffins, bagels etc.
4 Lower the lever 2 until it locks. The
‘cancel’ button will illuminate. (The
lever will not stay down unless the
toaster is plugged in).
l
To toast frozen bread, once the
bread is lowered press the ‘defrost’
button. The ‘defrost’ button will
illuminate.
l
To warm toast that’s popped up
but gone cold, lower the toast
then press the ‘reheat’ button. The
‘reheat’ button will illuminate.
l
Use the carriage lever to lift the toast
to Peek & View™ at any time
without cancelling the toasting cycle.
4